ASSEMBLY
The Clarity is shipped from the factory with the log set packed inside the firebox. To prepare the stove for installa- tion, the log set must be unpacked, the appropriate burner system module for either natural gas or propane installed, and the logs installed.
Removing the Glass Front
NOTE: The glass front is heavy. Be prepared for its weight when lifting it to avoid damage during removal.
The wing doors on each side are held closed by magnets. Push on each door to open it. Loosen the wing nut on each of the two levers. Grasp each lever and push to the rear to disengage the front. To keep the levers in the disengaged position, tighten the wing nuts. Lift the glass front slightly and remove it from the stove. Set the glass aside in a safe place where it will not be damaged.
WARNING: Do not abuse the Clarity's glass by striking, slamming, or similar trauma. Do not oper- ate the Clarity Vented Gas Heater with the glass panel removed,
1
2
3 4
The log set components are shipped from the factory individually wrapped and packed inside the stove. Take them out of the stove, then carefully remove the wrapping. Handle the logs gently as they may be damaged easily.
The front is released when levers on the left and right sides are pushed to the rear
cracked or broken. Use only glass supplied by Harman and approved for use with this heater. Do not use substi- tute materials. Replacement of the panel should be done by a licensed or qualified service person.
Remove and Unwrap the Log Set
As shown in the photo above right, the log set consists of a back log (1), a center log that has a
In addition, there are two side brick panels and a back brick panel.