Install the Side Brick Panels

Install the Back Log and Back Brick Panel

These two components are installed as a single piece. Rest the back brick panel on the shelf located on the back side of the back log, and center it. Holding the two pieces as a single unit, tilt the top forward slightly and manuever it over the top of the rear burner—taking care that the top corners clear the front opening. Place it snugly against the back wall and center it.

These slide into place along each side and are held by friction. The notch in each panel faces the back. Install one side, and then the other.

Install the Ember Strips

The ember strips rest against the front of the firebox and should fit snugly. Guide them toward you and to the outside until they fit snugly. Check the air slot in the inside of the ember strips to confirm that they do not obstruct it.

Install the Center Log

The center log goes all the way to the back and should be centered. When properly positioned, there should be an even gap along the front of the center burner in the cavity in the log. A small portion of the log support frame will be revealed.

The center log has a round viewing port in the left end through which the pilot can be observed.

Install the Branch

Orient the branch with the forked end toward the left rear of the stove and slip it over the two locator pins, one on top of the back log and the other on the top of the center log.

Secure the Glass Front

NOTE: The glass front is heavy. Lift it carefully to pre- vent damage. Center the glass on the opening and suspend it in place by placing the the tab hooks over the top edge of the opening. Loosen the wing nuts that hold the spring- loaded levers in place. Press the glass slightly against the stove to confirm that it seats properly, then press it firmly against the front while pulling the levers forward to engage them. Tighten the wing nuts.

The complete log set, with the logs installed and positioned correctly.