Harman Stove Company 929BV manual Operation, HOW to Light the Fire, HOW to Turn OFF the Fire

Operation

HOW TO LIGHT THE FIRE

1.STOP! Read the safety information on the left side of the panel below.

2.If using the optional thermostat, set thermostat to the lowest setting.

3.Turn off electric power to the appliance.

4.Turn the ON-OFF/THERMOSTAT switch to the OFF position.

5.Push in the gas con-

trol knob slightly and turn it clockwise to "OFF.". NOTE: The knob cannot be turned from "PILOT" to "OFF" unless it is pushed in slightly. Do not force it.

6.Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information on the label below. If you don't smell gas, go to the next step.

7.Set the High-Low Regulator to High by turning it fully counterclockwise.

8.Press in the gas control knob slightly and turn coun- terclockwise to "PILOT."

9.Find the pilot by looking through the round opening on the left end of the center log.

10.Push the control knob fully down and hold. Immedi- ately push the red piezo ignitor button to light the pilot. It is normal to have to push the red button several times before the pilot ignites. Continue to hold the control knob in for about one (1) minute after the pilot is lit. Release the knob and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 5 through 9.

•If the knob does not pop up when released, stop and immediately call your service technician or gas supplier.

•If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call your service technician or gas supplier.

11.Turn the gas control knob counterclockwise to

"ON."

12.Place the ON-OFF/THERMOSTAT switch in the ON position or in the THERMOSTAT position if the optional thermostat is used.

13.Turn on the electric power to the heater.

14.Set the optional thermostat to the desired room tem- perature.

15.Set the High-Low Regulator to desired setting: turn fully counterclockwise for High and fully clockwise for Low.

NOTE: An odor resulting from the initial heating of new materials in your heater is not unusual during the first fire, and in most cases will disappear after an hour or two.

HOW TO TURN OFF THE FIRE

1.If using optional thermostat, set thermostat to the low- est position.

2.Turn off the electric power to the appliance.

3.Turn the ON-OFF/THERMOSTAT switch to the OFF position.

4.Push in the gas control knob slightly and turn it clock- wise to “OFF.”

NOTE: The knob cannot be turned from “PILOT” to “OFF” unless it is pushed in slightly. Do not force it.

11