INSTALLATION
Specifications
Width: 27 ¼”
Height: 35 ½”
Depth: 28 ⅝”
Weight: 225 Pounds
Flue Size: 3” or 4 “
Hopper Capacity: 90 Pounds (Corn) (This will vary depending on fuel) EPA Status: Exempt
Maximum BTU Input: 50,000 BTU with whole corn
Approved Installations
Alcove, Conventional, Mobile Home
Preparation
Factory packaging must be removed, and some minor assembly work is required prior to installation and use. Access to the rear and sides of the stove will be necessary at some point in time so be sure to leave ample room for access, otherwise, be prepared to move the stove when necessary.
Install the ceramic Brick Panel onto the rear combustion wall. THIS IS A REQUIRED COMPONENT. The Brick Panel is fragile, so
handle with care at all times. Your stove warranty only covers this item from thermal breakage. Impact damage resulting from dropping or accidental abuse is not covered.
AUGER INSTALLATION: Install the auger into the auger tube as shown in Figure 2. The flat face of the auger is toward the front of the stove, and the beveled edge will go into the auger tube. Make sure the auger is all the way to the rear and is engaged or seated properly.
STIR ROD & BURN POT INSTALLATION: The Burn Pot must be set into the Burn Pot Holder with the fuel spreader towards the rear of the stove, as shown.
Insert the stir rod into the burn pot with the beveled connector toward the left. Align the beveled segments so that the holes on each piece align, and insert the cotter pin.
Pressing the Auger Feed button while the stove is off rotates the stir motor shaft. This will assist you in aligning these two pieces.
1