Moxa Technologies AWK-1200-AP user manual Inline Power Injector PoE

Page 7

MOXA AirWorks AWK-1200-AP User’s Manual

Introduction

Inline Power Injector (PoE)

The AWK-1200-AP is equipped with an Inline Power Injector module. The Inline Power Injector (PoE) delivers both data and power to the AWK-1200-AP unit through a single Ethernet cable, and provides the following benefits to improve the performance vs. installation cost ratio.

yGreat for areas that do not have a ready power supply, such as the roof of a house.

yAllows placing the AWK-1200-AP unit closer to the antenna, to make installation easier, and reduce signal loss over antenna cabling.

yEthernet signal travels well over CAT 5 cable but 2.4 GHz signal doesn’t do as well over antenna cabling.

yEthernet cabling is much cheaper than antenna cabling.

1-3

Image 7

Contents First Edition, July Moxa AirWorks AWK-1200-AP User’s ManualTrademarks Copyright NoticeDisclaimer Table of Contents Appendix C Regulatory Compliance Information Introduction System Requirements Package ChecklistProduct Features OverviewInline Power Injector PoE Getting Started Interface on the AWK-1200-AP Unit First Time Installation and ConfigurationInterface on the Inline Power Injector Locating the Data Input and PoE PortsMounting the AWK-1200-AP on a Wall or Mast Device FiguresStep What to Check before You Install the AWK-1200-APWeb Access Procedures Basic ConfigurationBasic Configuration Steps Web ConfigurationWeb Configuration Structure Help LAN SettingsWireless Network Name also called the Ssid Configuring the Wireless SsidConfiguring Wireless Encryption Changing the Supervisor Account & Password Updating the Firmware Upgrading the FirmwareMoxa AirWorks AWK-1200-AP User’s Manual Getting Started Web Console Configuration Basic WirelessMode Super G ModeWPA-Personal and WPA-Enterprise WPA-Enterprise WPA-PersonalAdvanced Enable MAC Address FilterMAC Address Filter MAC Address List Filter SettingsAdvance Wireless Add/Edit MAC AddressFragmentation Threshold 802.11d EnableTransmit Power WDS EnableTools AdminSystem Restore Configuration from FileSave Configuration To Wireless Network Setup Wizard TimeRestore all Settings to the Factory Defaults Reboot the DeviceFirmware Firmware Information Firmware UpgradeStatus Device InfoRate SignalLAN Computers MAC AddressView Levels Apply Log Settings NowLogs What to ViewStatistics Errors Wlan SpecificationsRegulatory Approvals Basic Default SettingsDhcp MAC Address Filter Advanced WirelessFirmware 15.21 Prohibition of co-location Regulatory Compliance InformationFederal Communications Commission FCC Requirements, Part Safety Information MPE Statement Safety InformationRegulatory information / Disclaimers