Casablanca Fan Company 59078 Light Kit, See next page for fan operation instructions, Notch, Bulb

Page 14
Light Kit

Light Kit

www.CasablancaFanCo.com

1.888.227.2178

Bulb

Install a halogen bulb in the

socket. When necessary, replace

with bulbs of the same type

and wattage.

Tab

Notch

Align the notches in the glass bowl with the tabs on the inside of the light kit.

Globe

Carefully lift the globe up inside the light kit as far as it will go, then rotate the globe clockwise until it is held tightly in place by the three tabs.

See next page for fan operation instructions.

When installing a halogen bulb, carefully cut off the end of the plastic sleeve packaging and hold the bulb by the plastic sleeve to screw it into the socket.

 

 

 

Note: In compliance with US federal energy regulations, this ceiling

 

 

 

fan contains a device that restricts its light output. Exceeding the

 

 

 

wattage limit marked on the MAX wattage sticker affixed to the

 

14

 

 

 

light socket(s) may result in fire hazard or improper operation.

 

 

 

 

M8510-01 • 04/15/15 • © 2013–2015 Casablanca Fan Company

Image 14
Contents Wiring Operation Table of ContentsWhat to Expect with Your Installation Troubleshooting2 Shorter Downrod What to Expect with Your Installation1 Standard Downrod 3 Longer DownrodPower Drill optional Tools NeededWire Strippers Ladderto hang the fan from a OPTION1OPTION to hang the fan from a flat ceilingMake sure all four bumpers are Ceiling BracketFor angled ceilings, point If you are unable to do thisIf you need a different downrod length follow these steps DownrodOption Steps 1-5 to remove standard downrod pipe3/8” Downrod continuedHAND TIGHTEN Let the canopy sit loosely on top of the fan CANOPY OR WIRES. Place the downrodDO NOT PICK THE FAN UP BY THE ball into the slot in the ceiling bracketWiring Wiring continued Wall Control Screw CanopyHoles Note Fan style may vary BladesInsert grommets found in thehardware Notch Light KitSee next page for fan operation instructions Globeto the receiver and ready to use OperationThe remote transmitter is already paired Power Operation continuedMaintenance & Cleaning Lights dim when turned on or do not turn on at all TroubleshootingAUTHORIZED SERVICE CENTERS Fan doesn’t workInstalling Multiple Fans Operating on a Single Remote Control Troubleshooting continuedInstalling Multiple Fans with Independently Operating Remote Controls Installing One Fan Operating on Multiple Remote Controls