Casablanca Fan Company 59077, 59078 Ceiling Bracket, For angled ceilings, point, still attached

Page 5

Ceiling Bracket

www.CasablancaFanCo.com

1.888.227.2178

OFF
	For angled ceilings, point
	opening toward peak.
	Use wood screws	Use machine screws
	(included) when securing	(provided with outlet
	to support structure with	box) when securing to
	approved electrical outlet	existing ceiling fan-rated
	box. Drill 9/64” pilot holes	outlet box. Make sure
	in support structure to aid	it is securely installed
	in securing ceiling bracket	and is acceptable for fan
	with hardware found in	support of 31.8 kg (70 lbs)
	the hardware bag.	or less.
Make sure all four bumpers are	If you are unable to do this,
still attached.	call Technical Support at	To avoid possible electrical shock, before
	1-888-227-2178.	To avoid possible electrical shock, before
	1-888-227-2178.	installing your fan, disconnect the power by
Refer to warning w.1 on pg. 2		turning off the circuit breakers to the outlet
Refer to warning w.1 on pg. 2		box associated with the wall switch location.
	5	box associated with the wall switch location.
	5

Image 5

Contents What to Expect with Your Installation Table of ContentsWiring Operation Troubleshooting1 Standard Downrod What to Expect with Your Installation2 Shorter Downrod 3 Longer DownrodWire Strippers Tools NeededPower Drill optional Ladder1OPTION OPTIONto hang the fan from a to hang the fan from a flat ceilingFor angled ceilings, point Ceiling BracketMake sure all four bumpers are If you are unable to do thisOption DownrodIf you need a different downrod length follow these steps Steps 1-5 to remove standard downrod pipe3/8” Downrod continuedHAND TIGHTEN DO NOT PICK THE FAN UP BY THE CANOPY OR WIRES. Place the downrodLet the canopy sit loosely on top of the fan ball into the slot in the ceiling bracketWiring Wiring continued Wall Control Screw CanopyHoles Note Fan style may vary BladesInsert grommets found in thehardware See next page for fan operation instructions Light KitNotch Globeto the receiver and ready to use OperationThe remote transmitter is already paired Operation continued PowerMaintenance & Cleaning AUTHORIZED SERVICE CENTERS TroubleshootingLights dim when turned on or do not turn on at all Fan doesn’t workInstalling Multiple Fans with Independently Operating Remote Controls Troubleshooting continuedInstalling Multiple Fans Operating on a Single Remote Control Installing One Fan Operating on Multiple Remote Controls