Casablanca Fan Company 59078, 59077 operation manual Operation continued, Power

Page 16
Operation (continued)

Operation (continued)

Fan

(Low)

Fan

 

Speed

 

Speed

 

 

(High)

Lights

 

Lights

Down

 

Up

Reverse

 

Fan

 

 

Power

Battery

Holder

Quickly press the up or down arrow to turn the lights off and on. Hold the up or down arrow to raise or dim the light level. The reverse button changes the direction that the blades turn. The power button turns the fan off and on.

Dimming Mode: To enable dimming, you must first set your remote to Dimming Mode. To toggle Dimming Mode on or off, hold down the Fan Power button while pressing the Light Down arrow twice.

Reverse Power

Button

(a)

(b)

The reverse button on the wall control changes the air flow pattern. In warm weather, use

(a)downward air flow pattern.

In cold weather, use (b) upward

air flow pattern.

16

www.CasablancaFanCo.com 1.888.227.2178 Manual background

The Safe-Exit Program gives you about thirty seconds of light when you turn the lights off to exit the room before the

lights go out.To use Safe-Exit:

Press the fan power button off for at least three seconds to initiate the Safe-Exit Mode.

The lights will flash for visual confirmation.

The lights will stay on 50% brightness for 20 seconds and then begin to dim. After a total of 30 seconds, the lights will be completely off.

Note: For CFL lighting, the lights will stay on 100% brightness for 30 seconds. After a total of

30 seconds, the lights will be

completely off.

M8510-01 • 04/15/15 • © 2013–2015 Casablanca Fan Company

Image 16
Contents Table of Contents What to Expect with Your InstallationWiring Operation TroubleshootingWhat to Expect with Your Installation 1 Standard Downrod2 Shorter Downrod 3 Longer DownrodTools Needed Wire StrippersPower Drill optional LadderOPTION 1OPTIONto hang the fan from a to hang the fan from a flat ceilingCeiling Bracket For angled ceilings, pointMake sure all four bumpers are If you are unable to do thisDownrod OptionIf you need a different downrod length follow these steps Steps 1-5 to remove standard downrod pipeHAND TIGHTEN Downrod continued3/8” CANOPY OR WIRES. Place the downrod DO NOT PICK THE FAN UP BY THELet the canopy sit loosely on top of the fan ball into the slot in the ceiling bracketWiring Wiring continued Wall Control Holes CanopyScrew Insert grommets found in thehardware BladesNote Fan style may vary Light Kit See next page for fan operation instructionsNotch GlobeThe remote transmitter is already paired Operationto the receiver and ready to use Power Operation continuedMaintenance & Cleaning Troubleshooting AUTHORIZED SERVICE CENTERSLights dim when turned on or do not turn on at all Fan doesn’t workTroubleshooting continued Installing Multiple Fans with Independently Operating Remote ControlsInstalling Multiple Fans Operating on a Single Remote Control Installing One Fan Operating on Multiple Remote Controls