Wall Control

www.CasablancaFanCo.com 1.888.227.2178

Drill Holes

Painter’s

Tape

Template

Screw

Cut-Out

Drywall

Anchors

Template

Drywall

Template

Before

Cover Plate

After

1.Tape the provided wall control template with painter’s tape at the desired installation area.

2.Drill holes inside the four corners of the template.

Note: Make sure the wall control template is level before proceeding to the next step.

1.Using a 9/64 drill bit, drill a hole in each screw cut-out on the wall control template.

2.Using a hammer, tap a drywall anchor found in the wall control hardware bag into each hole until the drywall anchor is flush with the wall.

1.Using a drywall punch saw, cut out the interior shape of the template using one of the four drilled corners as a starting point.

2.Remove the template and the cut-out section of drywall.

1. Insert the wall control into the dry wall cut out.

2.Align the screw holes in the wall control with the drywall anchors.

3.Install the cover plate using a Phillips Head screwdriver to secure the two cover plate screws found in the wall control hardware bag through the wall control and into the drywall anchors.

If you are using a outlet box for wall control installation, the wires coming from the wall control must be grounded using the attached green wire. If not placed in an outlet box, cap

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

the green wire coming from the wall control with an included wire nut.

any interference received, including interference that may cause undesired operation.