Casablanca Fan Company 59078, 59077 operation manual Canopy, Holes, Screw

Page 12
Canopy

Canopy

www.CasablancaFanCo.com

1.888.227.2178

Position the canopy so that, when lifted into place, the canopy fits into the hanging bracket as shown.

Screw

Holes

Lift the canopy into place so that

the screw holes are aligned.

Install the two canopy screws

found in the

hardware bag.

12

M8510-01 • 04/15/15 • © 2013–2015 Casablanca Fan Company

Image 12
Contents Table of Contents What to Expect with Your InstallationWiring Operation TroubleshootingWhat to Expect with Your Installation 1 Standard Downrod2 Shorter Downrod 3 Longer DownrodTools Needed Wire StrippersPower Drill optional LadderOPTION 1OPTIONto hang the fan from a to hang the fan from a flat ceilingCeiling Bracket For angled ceilings, pointMake sure all four bumpers are If you are unable to do thisDownrod OptionIf you need a different downrod length follow these steps Steps 1-5 to remove standard downrod pipeDownrod continued HAND TIGHTEN3/8” CANOPY OR WIRES. Place the downrod DO NOT PICK THE FAN UP BY THELet the canopy sit loosely on top of the fan ball into the slot in the ceiling bracketWiring Wiring continued Wall Control Canopy HolesScrew Blades Insert grommets found in thehardwareNote Fan style may vary Light Kit See next page for fan operation instructionsNotch GlobeOperation The remote transmitter is already pairedto the receiver and ready to use Power Operation continuedMaintenance & Cleaning Troubleshooting AUTHORIZED SERVICE CENTERSLights dim when turned on or do not turn on at all Fan doesn’t workTroubleshooting continued Installing Multiple Fans with Independently Operating Remote ControlsInstalling Multiple Fans Operating on a Single Remote Control Installing One Fan Operating on Multiple Remote Controls