Casablanca Fan Company 59077, 59078 operation manual Wiring

Page 9

Wiring

Receiver

Note: To connect the wires, hold the bare metal leads together and place a wire connector over them, then twist clockwise until tight.

www.CasablancaFanCo.com 1.888.227.2178

		M	CE	ILI
	O			N
R				G
F				G
F

Place the receiver on top of the downrod

Using an orange wire connector from thehardware bag:

Connect the 3 grounding wires (green, green/yellow stripe, or bare copper) coming from the ceiling, downrod, and ceiling bracket.

green/yellow stripe (grounding)

green/yellow stripe

		M
	O
R
F

FAN

assembly as shown.

Refer to CAUTION c.1 on pg. 2

R									T
F								E
								E
O							K
M	C					C
		E			A
				R
			B
			ILING

Turn the splices upward and push them carefully back through the hanger bracket into the outlet box. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box.

Image 9

Contents What to Expect with Your Installation Table of ContentsWiring Operation Troubleshooting1 Standard Downrod What to Expect with Your Installation2 Shorter Downrod 3 Longer DownrodWire Strippers Tools NeededPower Drill optional Ladder1OPTION OPTIONto hang the fan from a to hang the fan from a flat ceilingFor angled ceilings, point Ceiling BracketMake sure all four bumpers are If you are unable to do thisOption DownrodIf you need a different downrod length follow these steps Steps 1-5 to remove standard downrod pipeDownrod continued HAND TIGHTEN3/8” DO NOT PICK THE FAN UP BY THE CANOPY OR WIRES. Place the downrodLet the canopy sit loosely on top of the fan ball into the slot in the ceiling bracketWiring Wiring continued Wall Control Canopy HolesScrew Blades Insert grommets found in thehardwareNote Fan style may vary See next page for fan operation instructions Light KitNotch GlobeOperation The remote transmitter is already pairedto the receiver and ready to use Operation continued PowerMaintenance & Cleaning AUTHORIZED SERVICE CENTERS TroubleshootingLights dim when turned on or do not turn on at all Fan doesn’t workInstalling Multiple Fans with Independently Operating Remote Controls Troubleshooting continuedInstalling Multiple Fans Operating on a Single Remote Control Installing One Fan Operating on Multiple Remote Controls