Sharp HT-X1W E-22, Connecting the AC power lead, To turn the power on, for Use, Preparation

!Connecting the AC power lead

After checking all the connections have been made correctly, plug the AC power lead to the AC power input socket of the subwoofer/ amplifier unit, and then to the wall socket.

!To turn the power on

Press the ON/STAND-BY button.

If the power does not turn on, check if the AC power lead and sys- tem connection cable are plugged in properly.

HT-X1W

ENGLISH

1

Cooling fan

2

Wall socket

(AC 220 - 240 V, 50/60 Hz)

Notes:

Subwoofer/

amplifier unit

To set the system to stand- by mode:

Press the ON/STAND-BY button again.

Note:

After the system enters the power stand- by mode, wait a few sec- onds to turn on again.

for Use

"Never use a power lead other than the one supplied. Otherwise, a malfunction or an accident may occur.

"Unplug the AC power lead from the wall socket if the subwoofer/ amplifier unit will not be in use for a prolonged period of time.

AC Plug Adaptor

In areas (or countries) where a wall socket as shown in illustration is used, connect the unit using the AC plug adaptor supplied with the unit, as illustrated. The AC plug adaptor is not included in areas where the wall socket and AC power plug can be directly connected (see illustration ).

Note for users in Australia and New Zealand:

An AC plug adaptor is not supplied if the lead has an Australian Standard plug.

Cooling fan:

A cooling fan is built into this subwoofer/amplifier unit for better heat radiation. Do not cover the opening in this section with any obsta- cles to avoid damage to the subwoofer/amplifier unit.

Subwoofer/	Main unit
amplifier unit

Preparation

7

E-22

05/2/2 HT-X1W(LA)E3.fm TINSZA048AWZZ