ENGLISH
To install the main unit on the wall
Preparation:
Remove the stand from the main unit (perform steps 1 - 2 on page 15).
3Tighten the screws and remove the paper. Hook the main unit on the screw heads and make sure it is secure.
Sharp has designed the main unit so you can hang it on the wall.
5 mm (3/16")
3.2 mm (1/8")
Use appropriate screws (not supplied). See the il- lustration on the right for size and type.
Min. 22 mm (7/8") | 9 mm (3/8") |
Wall surface
Advanced Features
1Drive two screws into the wall for main unit, as shown in the illustration.
Make sure that both the screw and the wall can support a load of 2.2 kg (4.9 lbs.).
Drive the screws, so the screw head extends about 5.5 mm (7/ 32") out from the wall.
5.5 mm (7/32") |
Wall mounting screw |
Min. 16.5 mm (21/32") |
Wall surface |
2Fix the pattern paper and drive two screws into the wall with a distance of 130 mm
CAUTION:
!Make sure to prevent the main unit [2.2 kg (4.9 lbs.)] from falling when mounting on the wall.
!Before mounting, check the wall strength. (Do not put to the veneer plaster or whitewashed wall. The main unit may fall.) If it is not clear, consult with a qualified service technician.
!Mounting screws are not supplied. Use appropriate ones.
!Check all mounting screws for looseness and that they are engaged in the main unit.
!Mount the main unit on the wall with 2 screws.
!Select a good location. If not, accidents may occur or the main unit may get damaged.
!Avoid placing on a bed, sofa, water tank, sink and hallway wall.
!SHARP is not responsible for accidents resulting from improper installation.
Pattern paper for main unit
E-61
05/2/2 | TINSZA048AWZZ |