Casablanca Fan Company Casablanca Brescia Gallery Edition Installing the Switch Housing Assembly

Page 11

NO LIGHT KIT INSTALLATION

NOTE: THE FOLLOWING STEPS ARE TO BE PERFORMED ONLY IF YOU ARE NOT INSTALLING THE LIGHT KIT!

Step A1. Locate the switch housing/cap assembly and remove the two 8-32 X 3/8″ screws holding the cap onto the switch housing.

Note: Save these two screws–they will be used in Step A5!

SWITCH

HOUSING

CAP

CAP SCREW 8-32 X 3/8″

(2)

INSTALLING THE SWITCH HOUSING ASSEMBLY

Step A2. Attach the two (2) 5-32 X 9/32″ switch housing screws removed in Step 8 (on Page 6) to fan motor as shown, leav- ing 1⁄8" space for the switch housing installation.

Step A3. Lift the switch housing, run- ning the switch housing screws through the keyholes. Turn the switch housing right (clockwise) to engage the keyholes. Tighten securely by hand only.

KEYHOLE

SWITCH HOUSING

MOUNT SCREW

5-32 X 9/32″

(2)

INSTALLING THE CAP

Step A4. Line up the two clearance holes in the cap with the two threaded holes on the raised rim of the switch housing. Press the cap onto the switch housing to seat the guide pins into the alignment holes of the switch housing.

Step A5. Using the two (2) 8-32 X 3/8″ screws removed in Step A1, install the cap onto the switch housing.

Tighten securely by hand only.

CAP SCREW 8-32 X 3/8″

(2)

10

Page 10 Page 12
Image 11
Page 10 Page 12
Contents
Brescia Gallery Edition Safety First Determine Ceiling Angle Sloped Ceiling InstallationsMounting Recommendations FAN Preparation Preparation InstructionsPermalock Hardware Canopy Hardware Crossbar Mounting Bracket InstallationCanopy Installation Proceed with installation as followsCanopy Electrical Connections Canopy Hatch InstallationHanging the FAN Blade & Blade Holder Hardware Blade Installation Preparation Remove Shipping Blocks BLADE/BLADE Holder InstallationAttach Switch Housing Screws Prepare Switch Housing AssemblyAttach Light KIT Screws Install Switch Housing Assembly to Light FixtureAttach Switch Housing Secure with wire nutFAN Controls Light Fixture Glass InstallationTighten SCREWS, Install Bulbs & Place Glass Attach Light KIT to FANKeyhole Switch Housing Mount Screw Installing the Switch Housing AssemblyInstalling the CAP Or fuse panel before starting installation Intelitouch Installing the W-32 Wall ControlIntelitouch Single W-32 Installation Intelitouch Dual W-32 InstallationIntelitouch Operation Light Intelitouch Operation PowerIntelitouch Operation Speed Control Intelitouch Operation Reversing AirflowIntelitouch Operation FAN-MINDERPROGRAM Intelitouch Operation LIGHT-MINDERPROGRAMIntelitouch Operation SAFE-EXITPROGRAM Intelitouch Operation HOME-SAFEPROGRAMProblem Mounting Parts Wall Bracket InstallationBattery Installation LOW Battery WarningFAN Operation Additional Control FeaturesBulb-Saver Feature Test ProgramWinter Feature Reverse FeatureAUTO-SPEED Feature Saver FeatureComforttouch Changing Channels FAN Comforttouch Dual Remote Control BaseComforttouch Dual Remote Control Auxiliary Comforttouch Changing Channels ControlFAN O.K., no Light Remote Control of FAN is ErraticBattery Life Seems Short Temperature ReadingsPage Toll Free 888-CASA-1ST
Top Page Image Contents