Casablanca Fan Company Casablanca Brescia Gallery Edition Intelitouch Operation SAFE-EXITPROGRAM

Page 14

INTELI•TOUCH OPERATION LIGHT-MINDER®PROGRAM

The Light-Minder program automatically turns OFF the fan mounted lights after two hours.

To enter the Light-Minder Program:

1. Turn the OFF for at least three seconds.

2.Turn the ON.

3.Immediately operate the buttons in the following sequence:

+ + +

4. A series of tones indicates this command has been accepted.

The fan and light will operate normally using the buttons to turn them on and off. But, if the lights are left on, they will automatically shut off after two hours. To

cancel the Light-Minder Program, turn the off for three seconds.

INTELI•TOUCH OPERATION SAFE-EXIT®PROGRAM

The Safe-Exit Program gives you about thirty seconds of light when you turn the lights off, enabling you to exit your home before the lights go out.

To enter the Safe-Exit Program:

1.Turn the off for at least three seconds.

2.Turn the on.

3.Immediately operate the buttons in the following sequence:

+ + +

After you hear the confirming audio tones from the fan - immediately press

4. The lights will blink to indicate this command has been accepted.

The lights will stay on for twenty seconds and then begin to dim. After a total of thirty seconds has elapsed, the lights will be off completely. To

cancel the Safe-Exit Program, turn the off for three seconds.

Note: Both Light-Minder and Safe-Exit programs can run at the same time, however the dimmer cannot be used, the light may only be turned ON/OFF.

INTELI•TOUCH OPERATION HOME-SAFE®PROGRAM

The Home-Safe Program makes an unoccupied home appear occupied by turning the lights on and off at random times.

To enter the Home-Safe Program:

1.Turn the off for at least three seconds.

2.Turn the on.

3. Immediately operate the buttons in the following sequence:

+ + +

4. A tone and flashing light indicate this command has been accepted.

This program overrides all manual control of lights and fan. The lights will now be automatically cycled on and off in a controlled sequence as follows: On 1 hour, off 1/2 hour, on 2 hours, off 1 hour, on 1/2 hour then off 2 hours.

This seven hour pattern will repeat continuously so that a different pattern of lighting is seen each day of the week.

To cancel the Home-Safe Program, turn the off for three seconds.

INTELI•TOUCH OPERATION FAN-MINDERPROGRAM

The Fan-Minder feature will add to your comfort when used in the bedroom. The program reduces the speed of the fan each two-hour interval to compensate for the cooling night air.

To enter the Fan-Minder Program:

1.Turn the off for at least three seconds.

2.Turn the on.

3.Immediately operate the buttons in the following sequence:

+ + +

4.The fan controller will respond with three descending tones. A timer is now initiated and the fan will reduce one speed for each two-hour interval. The fan will not, however, descend below the

second lowest speed.

To cancel the Fan-Minder Program, turn the off for three seconds. You may increase the fan

speed by pressing and holding the button until the desired speed is reached, then release it. The fan will again reduce one speed for each 2 hour interval.

13

Image 14 Contents
Brescia Gallery Edition Safety First Determine Ceiling Angle Sloped Ceiling InstallationsMounting Recommendations FAN Preparation Preparation InstructionsPermalock Hardware Proceed with installation as follows Crossbar Mounting Bracket InstallationCanopy Installation Canopy HardwareCanopy Electrical Connections Canopy Hatch InstallationHanging the FAN Blade & Blade Holder Hardware Blade InstallationPreparation Prepare Switch Housing Assembly BLADE/BLADE Holder InstallationAttach Switch Housing Screws Remove Shipping BlocksSecure with wire nut Install Switch Housing Assembly to Light FixtureAttach Switch Housing Attach Light KIT Screws Attach Light KIT to FAN Light Fixture Glass Installation Tighten SCREWS, Install Bulbs & Place Glass FAN ControlsKeyhole Switch Housing Mount Screw Installing the Switch Housing AssemblyInstalling the CAP Intelitouch Dual W-32 Installation Intelitouch Installing the W-32 Wall ControlIntelitouch Single W-32 Installation Or fuse panel before starting installationIntelitouch Operation Reversing Airflow Intelitouch Operation PowerIntelitouch Operation Speed Control Intelitouch Operation LightIntelitouch Operation HOME-SAFEPROGRAM Intelitouch Operation LIGHT-MINDERPROGRAMIntelitouch Operation SAFE-EXITPROGRAM Intelitouch Operation FAN-MINDERPROGRAMProblem LOW Battery Warning Wall Bracket InstallationBattery Installation Mounting PartsTest Program Additional Control FeaturesBulb-Saver Feature FAN OperationSaver Feature Reverse FeatureAUTO-SPEED Feature Winter FeatureComforttouch Changing Channels Control Comforttouch Dual Remote Control BaseComforttouch Dual Remote Control Auxiliary Comforttouch Changing Channels FANTemperature Readings Remote Control of FAN is ErraticBattery Life Seems Short FAN O.K., no LightPage Toll Free 888-CASA-1ST