Casablanca Fan Company Casablanca Brescia Gallery Edition owner manual Remove Shipping Blocks

Page 8

BRESCIA (GALLERY EDITION)

REMOVE SHIPPING BLOCKS

Step 10. On the flywheel remove the four shipping blocks by unscrewing the screws. Discard the shipping blocks and shipping block screws.

SHIPPING

BLOCKS

BLADE/BLADE HOLDER INSTALLATION

Step 11. Using the screws from the pack, attach each blade/blade holder assembly to the motor.

Using the screwdriver, tighten securely by hand only.

 

BLADE

Your Brescia fan is equipped with a fly-

HOLDER

wheel that allows for both 4 and 5

SCREWS

blade installation. The screw holes sur-

 

rounded by squares are for 4 blade

 

installation, while the screw holes in

 

circles are for 5 blade installation as

 

shown above.

 

ATTACH SWITCH HOUSING SCREWS

NOTE: IF YOU ARE NOT INSTALLING THE LIGHT KIT, PLEASE SEE PAGE 10.

Step 12. Attach the two (2) 5-32 X 9/32″ switch housing screws removed in Step 8 to fan motor as shown, leaving 1⁄8" space for the switch housing installation.

SWITCH

HOUSING SCREWS

(FROM STEP 8)

PREPARE SWITCH HOUSING ASSEMBLY

Step 13. Locate the switch housing/cap assembly and remove the two 8-32 X 3/8″ screws holding the cap onto the switch housing. Set the cup aside in a safe lo- cation, you will need it if you ever decide to uninstall the light fixture.

Note: Save these two screws–they will be used in Step 16!

SWITCH

HOUSING

CAP

CAP SCREW 8-32 X 3/8″

(2)

7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents
Brescia Gallery Edition Safety First Determine Ceiling Angle Sloped Ceiling InstallationsMounting Recommendations FAN Preparation Preparation Instructions Permalock Hardware Crossbar Mounting Bracket Installation Canopy InstallationProceed with installation as follows Canopy HardwareCanopy Electrical Connections Canopy Hatch InstallationHanging the FAN Blade & Blade Holder Hardware Blade InstallationPreparation BLADE/BLADE Holder Installation Attach Switch Housing ScrewsPrepare Switch Housing Assembly Remove Shipping BlocksInstall Switch Housing Assembly to Light Fixture Attach Switch HousingSecure with wire nut Attach Light KIT ScrewsLight Fixture Glass Installation Tighten SCREWS, Install Bulbs & Place GlassAttach Light KIT to FAN FAN ControlsKeyhole Switch Housing Mount Screw Installing the Switch Housing AssemblyInstalling the CAP Intelitouch Installing the W-32 Wall Control Intelitouch Single W-32 InstallationIntelitouch Dual W-32 Installation Or fuse panel before starting installationIntelitouch Operation Power Intelitouch Operation Speed ControlIntelitouch Operation Reversing Airflow Intelitouch Operation LightIntelitouch Operation LIGHT-MINDERPROGRAM Intelitouch Operation SAFE-EXITPROGRAMIntelitouch Operation HOME-SAFEPROGRAM Intelitouch Operation FAN-MINDERPROGRAMProblem Wall Bracket Installation Battery InstallationLOW Battery Warning Mounting PartsAdditional Control Features Bulb-Saver FeatureTest Program FAN OperationReverse Feature AUTO-SPEED FeatureSaver Feature Winter FeatureComforttouch Dual Remote Control Base Comforttouch Dual Remote Control AuxiliaryComforttouch Changing Channels Control Comforttouch Changing Channels FANRemote Control of FAN is Erratic Battery Life Seems ShortTemperature Readings FAN O.K., no LightPage Toll Free 888-CASA-1ST
Top Page Image Contents