W-21 MOUNTING PARTS
|
|
| WALL BRACKET | |
|
|
| ANCHOR (4) | |
|
| ‘AAA’ ALKALINE | WALL BRACKET | |
REMOTE CONTROL | REMOTE CONTROL | BATTERY (3) | ||
SCREW (4) | ||||
WALL BRACKET |
| |||
|
|
WALL BRACKET INSTALLATION
Installation of Remote Control
The wall mounting bracket for the remote control should be located in a position that is approximately eye level. Secure the wall mounting bracket with the 11/4″ screws or anchors provided, making sure it is level with the floor.
CAUTION! DO NOT MOUNT REMOTE CONTROL ON OR NEAR A METAL SURFACE - ERRATIC OPERATION WILL OCCUR.
Changes or modifications not expressly approved in writing by Casablanca Fan Co. may void the user’s authority to oper- ate this equipment.
•••
This device complies with
Mount control in convenient location
WALL
MOUNTING
BRACKET
Remove for handheld or tabletop use
BATTERY INSTALLATION
Battery Installation
Install three ‘AAA’ alkaline batteries in the sequence shown and replace the battery compartment cover, then press the remote control firmly to the wall bracket so that the Velcro® pads grip the pads on the rear of the control. The remote control can be easily removed at any time should you wish to use it in another location. Just give the control a gentle tug to remove it.
REMEMBER THE REMOTE CONTROL WILL GO BACK TO THE ORIGINAL FACTORY ‘PRESET CHAN- NEL’ NUMBER WHEN THE BATTERIES ARE CHANGED. CHANGE CONTROL CHANNEL IF NEC- ESSARY AFTER BATTERY REPLACEMENT.
PRESET CHANNEL #
- | + | - | + |
|
| + | - |
SPACE
FOR
ROOM LABEL
LOW BATTERY WARNING
Low Battery Indicator
The remote control warns of a low battery condition by displaying a rapidly flashing ‘Lo’ in place of the temperature display. When this occurs replace with fresh alkaline battery.
WARNING: Use of batteries other than
Note: When the remote is in the low battery mode the fan may not respond to control commands correctly even though the fan may be running.
15