Casablanca Fan Company Casablanca Brescia Gallery Edition Intelitouch Single W-32 Installation

INTELI•TOUCH© INSTALLING THE W-32 WALL CONTROL

The wall control installs in the same manner as an ordinary light switch, using an existing junction box and wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed:

1.Use only the Casablanca W-32 wall control.

2.Do not use any additional control with your Inteli-Touch fan (for example, dimmer, fan speed control, etc.).

3.Do not use more than one fan per wall control.

4.No other light fixtures or electrical appliances may be con- nected on the circuit controlled by the W-32 wall control.

INTELI•TOUCH ♦SINGLE W-32 INSTALLATION

CAUTION! Ensure power is turned OFF at the breaker or fuse panel before starting installation.

W-32 is used to describe either white (-11) or ivory finish.

1. Remove the screws and switch plate from the existing switch box.

2. Remove the screws holding the switch in the switch box.

3. Pull the existing switch from the switch box to expose the wire connections.

4. Remove the two wires from the switch.

5. Connect the two wires just removed from the switch to the W-32 wall control black wire and black/white stripe wire. Secure these connections with wire nuts.

6. Install the W-32 in the wall box with the two long screws provided.

7. Install the wall plate with the two color matched screws.

NOTE: If wall control operation is reversed (fan switch controls lights and light switch controls fan) turn off the power at the breaker or fuse panel, then swap the two W-32 black/white stripe wires.

INTELI•TOUCH ♦DUAL W-32 INSTALLATION

CAUTION! Ensure power is turned OFF at the breaker			SWAP THESE TWO WIRES
or fuse panel before starting installation.
			WHEN NECESSARY
To control the fan and lights from two locations (a			(SEE NOTE BELOW)
three-way circuit), use 2 W-32 wall controls.
1.	Remove the screws and switch plate from the ex-
	isting switch box and the screws holding the switch
	in the switch box.
2.	Pull the existing switch from the switch box to
	expose the wire connections.
3.	Determine which wire is connected to the common
	terminal of the 3-way switch. (The terminal will be
	marked on switch).
4.	Remove the wire from the common terminal of the
	3-way switch. Connect this wire to the remaining
	black/white striped wire on the W-32 control. Se-
	cure this splice with a wire nut.	END
5. Remove the two remaining wires from the 3-way			IN
		OF
	switch. Connect one of these wires to a black wire		LINE
		LINE
	on the W-32 control. Secure the splice with a wire
	nut. The remaining wire is to be connected to the
	other black wire on the W-32. Secure the splice
	with a wire nut.
6. Install the W-32 in the wall box with the two long
	screws provided.
7. Install the wall plate with the two short color-
	matched screws provided.	NOTE: If wall control operation is reversed (fan switch controls
8. Installation of the second W-32 control is identi-
		lights and light switch controls fan) turn off the power at the breaker
	cal. Repeat steps 1 through 7.
		or fuse panel, then swap the two W-32 black/white stripe wires.

11