INSTALLING THE BLADE/BLADE HOLDER TO FAN MOTOR
PREPARATION
Step 8. To reach the blade holder mounting holes in the fan motor the dummy switch housing must be removed.
Take out the two
The dummy switch housing is used only when shipping the fan.
Note: Save these two
DUMMY SWITCH HOUSING
BLADE & BLADE HOLDER HARDWARE
BLADE SCREW (4 PER BLADE)
BLADE HOLDER
SCREW
(2 PER BLADE)BLADE HOLDER
BLADE INSTALLATION
Step 9. Attach the blades to the blade holders by first pressing the blade badge into the blade, then installing the blade holder using the four blade screws and flat washers provided for each blade.
Using the screwdriver, tighten securely by hand only.
Repeat for each blade assembly.
BLADE SCREW (4 PER BLADE)
BLADE
HOLDER
BLADE
BADGE
BLADE
6