CROSSBAR MOUNTING BRACKET INSTALLATION
Proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box through the crossbar mounting bracket center hole. Attach the bracket, with ground wire and ridges down, to the ceiling fixture out- let box with the mounting hardware included with the outlet box.
Tighten the screws firmly by hand only, being careful not to bend the bracket by over tightening.
CAUTION: To reduce the risk of personal injury, use only the mounting hardware provided with the approved outlet box to install the crossbar mounting bracket.
CEILING FAN
APPROVED
OUTLET BOX
CEILING
WIRING
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
OUTLET BOX
MOUNTING
HARDWARE
RIDGE
SIDE
DOWN
GREEN
GROUND
WIRE
CANOPY HARDWARE
CANOPY SCREW (4)
CANOPY | CANOPY LOCK WASHER (4) |
HATCH | CANOPY |
CANOPY INSTALLATION
Step 2. Attach the canopy to the crossbar mount- ing bracket with three of the
Tighten the screw firmly by hand only.
Note: On sloped ceilings, align the canopy opening towards the top or room peak.
CROSSBAR MOUNTING
BRACKET INSTALLED
CANOPY
CANOPY LOCK
WASHERS
CANOPY
SCREWS
4