EXTENSION TABLE
a. REMOVING THE EXTENSION TABLE Hook your finger to the left bottom side of extension table and slide it to the left. To attach, insert to the right.
b. OPENING THE ACCESSORY CASE Hook your finger to the left side of accessory case and pull toward you.
CHANGING THE PRESSER FOOT
The presser foot must be changed according to the stitch you sew, or work you do.
CAUTION: To prevent accidents. Turn off the power switch before you change the presser foot.
A. Changing the presser foot
1.Turn the hand wheel toward you until the needle is at its highest point.
2.Raise the presser foot lifter.
3.Remove the presser foot by pushing the presser foot release lever toward you.
4.Place desired foot with its pin directly under the slot in presser foot holder.
5.Lower the presser foot lifting lever and the presser foot will snap into place.
B. Removing the presser foot holder When attaching the special presser foot or cleaning the machine, you should remove the presser foot holder.
1.Remove the presser foot.
2.Loosen the presser foot thumb screw and remove the presser foot holder.
3.To replace the holder, pull up the holder as far as it will go from bottom of presser bar.
4.Tighten the thumb screw.
7