ASSEMBLY INSTRUCTIONS (continued)
REMOTE CONTROL BATTERY INSTALLATION/ REPLACEMENT INSTRUCTIONS
A.Remove battery door by sliding downward in direction of arrow.
B.Insert 2 AAA batteries into the remote following the directional guides in the recessed slots (Fig. 9). Batteries are included.
C.Replace battery door by sliding upward opposite of arrow direction until door snaps in place.
Fig. 9
NOTE: DO NOT MIX OLD AND NEW BATTERIES. DO NOT MIX ALKALINE, STANDARD
SEE RECYCLERS IN YOUR AREA FOR PROPER DISPOSAL OF BATTERIES.
ON/OFF
To turn fan on, press the Power button () located at the bottom of the control panel (Fig. 10).
SPEED CONTROL
To adjust the speed up or down, press the Fan Speed button () repeatedly to increase level (Fig. 10).
TIMER
Choose from 1, 2, 4, or 8 hour settings by performing the following function (Fig. 10):
•1 hour:
Press the Timer button () once.
•2 hours:
Press the Timer button twice.
•4 hours:
Press the Timer button a third time.
•8 hours:
Press the Timer button a fourth time.
Press the Timer button a fifth time to turn the Timer feature off.
OSCILLATION
•Oscillation Knob is located on the top panel of the Motor Assembly behind the Carry Handle.
•To START fan oscillation, push the Oscillation Knob DOWN.
•To STOP fan oscillation, pull the Oscillation Knob UP.(Fig. 11).
Model | Model |
Speed
Timer
Power
Fig. 10
Fig. 11
Up/ Down/
OFF ON
Oscillation knob
5