APC ACF102BLK manual Installation, Remove the rear doors

Page 9

Installation

Remove the rear doors

To avoid personal injury or damage to the enclosure, one person should support the door while another removes it from the frame.

Warning

1. If necessary, move the rack to allow for at least 30 inches of clearance to install the Rack Air Removal Unit.

2. Open the rear doors and pull down on the spring-loaded hinge pin attached to the top of the door. Lift the door from its frame and set it safely aside.

3. Repeat this step with the other rear door.

4. Using the included M5 hex wrench, remove the door bumpers at the top and bottom of the door frame.

NetworkAIR Rack Air Removal Unit Installation

5

Image 9

Contents NetworkAIR Rack Air Removal Unit Page Contents Life-Support Policy Features General InformationIntroduction Safety Information Inventory Before You BeginReceiving inspection Tools requiredRemove the rear doors InstallationInstall the fan frame Install the fan assembly Optional Items Start-up OperationConnect the power supply Temperature override How to set the fans based on wattageTemp Override How to set the temperature override Temperature OverrideHow to set the fans based on temperature LED legend Alarm SettingsHow to connect to the A-Link How to Communicate Using the A-LinkHow to Communicate Using the A-Link Chart Limited warranty Warranty and ServiceWarranty limitations Obtaining serviceLife-Support Policy General policyExamples of life-support devices 230VAC 50Hz Specifications ACF102BLKPage Page APC Worldwide Customer Support