Blower Exit Elbow Assembly Installation
The following procedure includes the steps necessary for installing the Blower Exit Elbow Assembly on the DR LEAF and LAWN VACUUM.
1.Install the Blower Exit Elbow Assembly on top of the Blower with the elbow pointing toward the Collector Box (Figure 14).
2.Align the hood of the Blower Exit Elbow Assembly to assure that the Safety Interlock Switch is engaged, verify the position of the Lanyard as shown, and then install a Lock Washer and Flat Washer over each of the four
(4) 5/16" x 1/2" Wing Screws and hand tighten them to the blower housing (Figure 14).
Tip: Start all four (4) Wing Screws before tightening them securely.
Note: If the Safety Interlock Switch is not engaged, the engine will not start. Adjust the switch mounting bracket by loosening the bracket bolt and sliding the bracket up so that the button on the switch is fully depressed against the Blower Exit Elbow Assembly.
Collector
Box Hose
Blower Exit
Elbow
Assembly
Lanyard | Safety |
Interlock | |
Angle | Switch |
Adjusting | |
Wing Screw |
|
2 places |
|
Wing Screw |
|
4 places |
|
| Loosen |
| Bolt to |
Figure 14 | Adjust |
|
Connecting the Collector Box Inlet Hose to the Blower Exit Elbow Assembly
The following procedure includes the steps necessary for connecting the Collector Box Inlet Hose to the Blower Exit Elbow Assembly on the DR LEAF and LAWN VACUUM.
1.Connect the hose from the Collector Box to the Blower Exit Elbow Assembly by aligning the two flexible latches (Figure 15) and slipping the hoses together.
2.Pull and hook the two flexible latches into place (Figure 15) to secure the hoses.
Note: Align the Exit Elbow with the hose by loosening the two (2) Wing Screws (Figure 14) one or two turns and then turn the Elbow to align with the hose.
Pull & Hook
Flexible Latches
Hook here
Collector
Box Hose
Blower Exit Elbow
Figure 15
16 | DR COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions |