Country Home Products DR manual Blower Inlet Hose Tools Needed, Support Tie, Cut excess here

WARNING! Before performing any maintenance procedure, stop the engine and disconnect the spark plug wire.

Blower Inlet Hose:

Tools Needed:

Diagonal or wire cutter

Screw driver or nut driver

1. Cut the support tie around the
Blower Inlet Hose (Figure 43).			Clamp
2. Loosen the clamp retaining the
Inlet Hose at the Inlet Hose
Adapter and the connector fitting	Lanyard
at the opposite end of the hose.
Then slip the hose off the adapter
and fitting (Figure 43).
3. Install the new hose in the reverse
order making sure that the clamps
are positioned on the blower side
of the raised rivet in the Inlet Hose
Adapter and on the fitting side of
the raised rivet in the connector
fitting to prevent the hose from
slipping off after the clamps are			Blower
tightened.			Inlet Hose
4. Check the Safety Interlock Switch
to be sure that it is engaged.		Support Tie,
5. Install a new Support Tie, through		cut excess here
the Lanyard and around the Inlet
Hose about half way along the
hose (Figure 43). Cut off excess		Figure 43
Support Tie.

Safety

Interlock

Switch

Inlet

Hose

Adapter

DR COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions 37