B. Join upper and lower handles
Join upper and lower handles, aligning holes.
Place cord clip around cord with flat side toward handle of cleaner and holes to the front.
Insert bolt through washer, cord clip and both parts of the handle (small holes). Secure with nut. Pull up slack in cord and tighten nut with screw- driver.
C. Attach cloth bag to cleaner
The cloth bag is connected at the rear of the cleaner. There are two projections at the bottom of the cloth bag assembly.
To attach cloth bag to the cleaner, place the two projections at the bot- tom of the cloth bag assembly inside the metal grooved plate. (You will find the grooved plate extending out from the bottom of the cleaner.IFig.1.
Just above the opening at the rear of the cleaner is the bag clip. Pull the bag clip to the left and fit bag against opening. When you release the bag clip, it should move to the right and fit completely over the bag lock. Fig.2.
Attach the bag to the bag spring hook, which is located on the top section
of the handle. Fig. 3.
HOW TO USE YOUR CLEANER
How to operate
Operate cleaner only at voltage speci- fied on data plate on bottom of cleaner.
Warning: Electric shock could occur if
used outdoors or on wet surfaces.
I
On-off switch
The
4