Eureka 5190 Series warranty To Change Cassette Micron Filter, To Change the Cassette Micron Filter

Page 13

To Change Cassette Micron Filter:

NOTE: Turn off the switch and unplug the electrical cord before changing the Cassette Micron Filter. Never operate the vacuum cleaner without the cyclonic cassette or the filter.

2

Remove cyclonic cassette by pushing up lever (1), unhooking (2) by swinging outward from vacuum body. When replacing cyclonic cassette, hook at top where shown (2), and swing back into place until lever (1) snaps into place.

Check and clean the Cassette Micron Filter once a month to maintain good performance. The filter can be cleaned by vacuuming with another cleaner or brushing dust off into the trash. Recommended changing of the Cassette Micron Filter is once every three months.

To Change the Cassette Micron Filter:

1

1.Remove the filter frame by grasping the handle on the back of the filter frame and pulling firmly. The filter frame will drop down staying connected at the hinges on the bottom.

2.Remove old filter from filter frame and replace with a new filter.

3.Reconnect filter frame to cassette body by swinging filter frame up and pushing against cassette body until it snaps into place.

Use GENUINE EUREKA replacement filter, 60696. Look for the GENUINE EUREKA product symbol.

 

 

2

1.

Filter Frame

1

 

 

2.

Filter

 

3.

Cassette Body

 

 

 

3

How To Empty Cyclonic Cassette

NOTE: Turn off the switch and unplug the electrical cord before emptying cyclonic cassette. Never operate the vacuum cleaner without the cyclonic cassette or the filter.

FOR INSTRUCTIONS ON HOW TO REMOVE THE CYCLONIC CASSETTE FROM THE CASSETTE BODY, SEE ABOVE.

Emptying the Cyclonic Cassette:

It is clearly visible when the dust compartment is full and needs emptying. Lift screen as shown (3) to completely empty cyclonic cassette. It is possible to clean out the cyclonic cassette by using another vacuum.

CAUTION: The cyclonic cassette can be washed in warm water, if desired, but strong detergents should not be used. Dry thoroughly before using again.

3

NOTE: The compartment with the screen (a) will fill much faster with larger dirt particles than the compartment with the cone (b). This is normal, empty the cyclonic cassette when the side with the screen is full, do not wait for the side with the cone to fill completely.

b

a

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Product to the store Do not return thisImportant Safeguards Conseils DE Sécurité General Information Service InformationUSA México Canada Rating PlateHOW to Assemble Vacuum Cleaner Handle Self-Propelled Selector HOW to USE the SELF-PROPELLED Vacuum CleanerHow to Adjust the Cleaner Height Setting HOW to USE the SELF-PROPELLED Vacuum CleanerUse Clean Under Furniture Beds, etc Extension Wand Nested Extension Wand to add reach HOW to USE the AccessoriesHose Strap Hose Upper Retainer Hose Nozzle Lower Hose Strap HookHow to Check the Dirt Alert Sensors Maintenance of Dirt Alert Feature On some modelsTo check if dirt sensor is working properly How To Replace Brush Roll Belt HOW to MaintainBrush Roll Brush Roll BeltRotate End Cap Left Right Detail Brush RollDetail Hose Assembly Hose Retainer HOW to Clear Hose ClogsTo Change Cassette Micron Filter How To Empty Cyclonic CassetteTo Change the Cassette Micron Filter Emptying the Cyclonic CassetteHow To Replace Filters Lift lens cover from cleaner Lens Cover Handle Release How to Change Light Bulb only for models with a headlightUse 15 watt replacement light bulb, part number Problem Solving Cause Solution Genuine Eureka Bags, Belts and Filters Accessories/ToolsHoses Miscellaneous PartsPage USA Mexico Canada Eureka Limited WarrantyUpholstery nozzle Dusting brush Crevice tool Wands M. to 8 p.m., Central Standard Time, Monday through Saturday
Top Page Image Contents