HOW TO USE
The upright vacuum cleaner design allows use on multiple types of carpeting and on upholstery or bare floors with attachments. When using the attachment tools, place the handle in the upright position. Do not place cleaner on furniture or steps as the brush roll may cause damage.
1. Adjust cleaner height setting knob to lowest position for maximum cleaning. Adjust to a higher setting to make pushing easier. For easy adjustments, tilt the cleaner back to move the knob.
2. Plug electrical cord into outlet.
2
3. Step on handle release. Pull handle back to a comfortable position.
4. Push On/Off power switch.
Store or
Use Attachments
Use | 4 ON/OFF |
Handle
3 Release
Clean
Under
Handle
3 Release
Cleaner Height Setting
WARNING: Avoid injury. Keep loose clothing, hair, fingers, and all other parts of body away from any moving part (such as the revolving brush). Turn off the switch and unplug the cleaner before changing the cleaner height setting.
The front of the cleaner has an adjustment that raises or lowers the cleaner base to match the type of carpet. With the cleaner cord unplugged, set the adjustment to lowest setting for maximum cleaning. If the cleaner is difficult to push, move adjustment to next highest setting until cleaner is comfortable to push. The brush roll must reach the carpet for effective cleaning.
NOTE: For ease in moving the adjustment knob, place handle in operating position and tilt cleaner back to remove weight from front wheels.
NOTE: When handle is in upright position, brush roll is lifted off carpet. This is normal. Height adjustment will not change brush roll level until the cleaner’s handle is moved into the operating position.
1
THERMAL CUT OFF
This cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly turns off, follow this procedure:
1.Push on/off pedal once.
2.Unplug cleaner.
3.Check for source of overheating problem (i.e. full cyclonic cassette, clogged hose or clogged filter).
4.If a full cyclonic cassette, clogged hose or clogged filter is found, empty the cyclonic cassette, unclog the hose or replace the filters.
5.Wait at least 30 minutes before attempting to reuse the cleaner.
6.After 30 minute cool down period, plug the cleaner in and push the switch pedal. The cleaner should turn on.
7.If the cleaner still does not operate, take it to any Eureka Authorized Service Center for repair.
7