Thank you for selecting a Bissell product | Bissell 83V5 specification

Troubleshooting

DirtLifter PowerBrush does not turn

Possible cause	Remedies
1. The brush belt or pump belt is off or broken.	1. Refer to Remedy 4 on page 16 to check if brush belt or
	pump belt is broken.

Cleaner not picking up solution

Possible cause

1.ReadyTools dial may be on the wrong setting for the cleaning job.

2.Poor tool position. (Hand held attachments only).

3.Removable nozzle may not be properly attached.

4.2-in-1 water tank lid is not properly installed.

5.2-in-1 water tank is not properly seated.

6.2-in-1 water tank has picked up maximum dirty water.

7.The lint screen may be clogged.

Remedies

1.Set ReadyTools dial to either FLOOR CLEANING or TOOLS.

2.Adjust angle; apply more downward pressure.

3.Make sure nozzle is on correctly by slightly raising front of machine to line up slots on the base of the machine with the hooks on nozzle. Attach at base first and then click nozzle into place. Refer to image 5 on page 12.

4.Re-install lid; refer to the images on page 10.

5.2-in-1 water tank must be firmly seated to function; remove and reseat 2-in-1 water tank.

6.Empty 2-in-1 water tank and refill, refer to the Operation section.

7.Clean out lint screen. Refer to page 12.

Other maintenance or service not included in the manual should be

performed by an authorized service representative.

Thank you for selecting a BISSELL product.

Please do not return this product to the store.

w w w . b i s s e l l . c o m