Secondary Installation
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE GLASS DOOR REMOVED.
Important note: When the unit is turned on for the first time, it should be turned onto high without the fan on for the first four (4) hours. This will cure the paint, logs, gasket material and the other products used in the manufacturing process. It is advisable to open a window or door, as the unit will start to smoke and can irritate some people. After the unit has gone through the first burn turn the unit off including the pilot, let the unit get cold then remove the glass door and clean it with a good gas fireplace glass cleaner, available at your local ENVIRO dealer.
See Maintenance And Service on how to
remove door to clean glass.
Figure 43: Cara DR with a Good Flame.
Installation of Rock Set:
If the rocks are positioned incorrectly, the flames can be “pinched” and will not burn correctly. If the rocks are broken due to handling or shipping, replace the rocks with new ones. Using the pictures provided, carefully set the rocks in place.
NOTE: The rocks are fragile, particularly after usage. Please handle with due care during servicing.
1.Carefully remove rocks from box and check there is no damage. It is very important to install all rocks in their proper position to ensure safe, optimum operating conditions.
2.Place the rock cluster onto the burner. There are two (2) holes at the back corners of the burner and two (2) aligning pins on the bottom of the rock cluster (refer to Figures 44 & 45).
Figure 44: Installation of Rock Cluster.
27
