Enviro C-11500 owner manual Secondary Installation, Do not install when the unit is hot

Secondary Installation

Important note: When the unit is turned on for the first time, it should be turned onto high without the fan on for the first four (4) hours. This will cure the paint, rockss, gasket material and the other products used in the manufacturing process. It is advisable to open a window or door, as the unit will start to smoke and can irritate some people. After the unit has gone through the first burn turn the unit off including the pilot, let the unit get cold then remove the glass door and clean it with a good gas fireplace glass cleaner, available at your local ENVIRO dealer. See Maintenance And Service on how to remove door

to clean glass.

Installation of Ceramic Firebox Liner (Optional):

Brick Panel Clip

Steel Firebox Liner

Figure 49: Steel Firebox Liners Installation.

Do not install when the unit is hot.

The firebox liner is fragile. Handle liners with care and avoid knocking them on any object.

The Enviro Cara DR comes with a Steel Firebox Liner installed, which must be removed if a Ceramic Firebox Liner is to be installed.

1. Remove the glass door as shown in the Maintenance

and Service - Glass Door Removal.

2.Carefully remove the log set.

3.Slide the burner tray back just far enough so the front edge of the burner does not catch on the front lip of the firebox. Lift the front of the burner up and out of the firebox.

4.Using a T-20 screwdriver, remove the left and right Brick Panel Clips

5.Remove the Steel Firebox Liner by pulling the left side of the panel in towards the center of the unit then out a little. Repeat for the right side then pull the panel completely out.

6.Install the rear ceramic liner by placing it against the back of the firebox. The top of the liner has an angled edge, the bottom does not. Note: The Firebox Baffle must be in place for the Firebox Liners to be installed.

Figure 50: Firebox Liners Installation.

7.While holding the rear ceramic liner from falling forward, install the left and right liners by sliding them in against the sides of the firebox and up to the rear liner (refer to Figure 50).

8.Attach and tighten the brick panel clips with the screws provided. The side liners hold the rear liner in place.

9.Re-install the burner (see Maintenance and Service - Burner Removal & Installation), log set (see Secondary Installation - Log Set Installation), and the door.

29