Enviro C-11500 Initial Installation, Qualified Installers Only, Manufacturer, Trade Name

Initial Installation

QUALIFIED INSTALLERS ONLY

Planning Your Installation:

The Cara DR is only for horizontal rear vent installations. The maximum horizontal is 2’ (61 cm) and the slope on the vent must be 1¼” per foot (3.2 cm per 30 cm). No vent restrictor is required and no elbows are allowed. When planning your installation, it will be necessary to select the proper length of vent pipe for your particular requirements. It is important to note when passing through a wall, the maximum allowable wall thickness is 10 inches (25.4 cm); 1½ inches (3.8 cm) clearance to combustibles must be maintained. To connect the venting system to the appliance flue outlet, a twist-lock adapter is built into the appliance at the factory.

Note: If necessary to get above grade the Cara DR can be installed using a 14” or 36” snorkel.

Approved Vent Parts:

Table 5: Approved Vent Manufacturers.

	Manufacturer				Trade Name		Nominal Sizes
	American Metal Products				AmeriVent Direct			4” - 6 5/8”
	Security Chimneys International LTD				Secure Vent			4” - 6 5/8”
	Selkirk Metalbestos				Direct-Temp			4” - 6 5/8”
	Simpson Dura-Vent				Direct Vent GS			4” - 6 5/8”
	Table 6: Vent part numbers (Must state if galvanized or black wanted, PART NUMBERS).
Direct Vent GS		Direct-Temp	Secure Vent	Ameri Vent Direct		Description
908		4DT-6	SV4L6			6” pipe length
					4D7	7” pipe length
907		4DT-9				9” pipe length
906		4DT-12	SV4L12		4D12	12” pipe length
904		4DT-24	SV4L24		4D2	24” pipe length
942		4DT-WT	SV4RSN		4DWT	Wall thimble
970		4DT-HKA	SV0SHK		4DHTK1	Horizontal termination kit (SD: Basic Kit,
						SEL: Kit A, SC: Standard Kit)
984		4DT-HC	SV4CHC		4DHC	Horizontal square termination

The Cara DR fireplace has been tested and certified for use with AMERICAN METAL PRODUCTS “AMERIVENT DIRECT”, SIMPSON DURAVENT TYPE GS PIPE FOR GAS STOVES. SECURITY CHIMNEY’S “SECURE VENT DIRECT VENT SYSTEM” and SELKIRK “DIRECT-TEMP VENT SYSTEM” kits are available for horizontal venting. When using Simpson Duravent, it is recommended that, before installation, a bead of RTV High Temperature Silicone should be applied to each outer vent joint, and Mil-Pac to each inner joint. When planning an installation, it will be necessary to select the proper length of vent pipe for the particular requirements.

WARNING: Do not mix parts from different vent manufacturers’ systems. EXCEPTION TO WARNING: This product has been evaluated by Intertek for using a Direct Vent GS starting collar in conjunction with Secure Vent, Direct-Temp, and Ameri Vent Direct venting systems. Use of these systems with the Direct Vent GS starting collar is deemed acceptable and does not affect the Intertek WH listing of the appliance.

15