INSTALLATION
Continued
Ember
Chunks
Figure 9 - Placement of Top Logs
OPERATING APPLIANCE
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: Keep flue open when operating unit.
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.
BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighborʼs phone. Follow the gas supplierʼs instructions.
•If you cannot reach your gas supplier, call the fire department.
LIGHTING
INSTRUCTIONS
1.STOP! Read the safety information on column 1.
2.Turn the gas shutoff valve to OFF.
3.Wait five (5) minutes to clear out any gas. If you then smell gas STOP! Follow the safety information column 1. If you don't smell gas, go on to the next step.
4.Light a match and lay it on top of the pan material about 2" from the end of the sup- ply side of the pan
5.Slowly turn the gas shutoff valve ON until the burner ignites. If the burner doesnʼt ignite within 10 seconds with the match burning, turn the shutoff valve OFF and repeat steps 1 through 4 again.
| GAS SHUTOFF |
|
VALVE OPERATION |
| |
Flame Adjustment |
| |
Adjust the flame ON/OFF by turning the gas | ||
shutoff valve counterclockwise | to open | |
or clockwise | to close, as necessary. | |
Shutting Off Appliance |
| |
Turn gas shutoff valve clockwise | to the | |
OFF position. |
| |
| CURING |
|
| LOGS |
|
During the | ||
you may detect an odor from the appliance | ||
as the various paints and compounds used in | ||
the manufacturing of this log set cure. This is | ||
a normal and temporary situation that is not | ||
cause for alarm. However, you may want to | ||
provide extra ventilation to the room during | ||
this time. |
|
|
To ensure proper curing of the logs: |
| |
•Ignite a 2" flame and maintain it for 1 hour.
•Burn the logs in consecutive 1 hour periods raising the flame an additional 2" to full flame height for a total of three hours.
www.desatech.com | 9 |