SAFETY INFORMATION
Continued
1.If you smell gas
•shut off gas supply
•do not try to light any appliance
•do not touch any electrical switch; do not use any phone in your building
•immediately call your gas supplier from a neighborʼs phone. Follow the gas supplierʼs instructions
•if you cannot reach your gas supplier, call the fire department
2.Never install the log set
•in a recreational vehicle
•where curtains, furniture, clothing, or other flammable objects are less than 42 inches from the front, top, or sides of the log set
•in high traffic areas
•in windy or drafty areas
3.Before installing in a solid fuel burning fireplace, the chimney flue and firebox must be cleaned of soot, creosote, ashes and loose paint by a qualified chimney cleaner. Creosote will ignite if highly heated. Inspect chimney flue for damage. If dam- aged, repair flue before operating appliance.
4.This log set is designed to be smokeless. If logs ever appear to smoke, turn off appliance and call a qualified service person. Note: During initial operation, slight smoking could occur due to log curing and the burning of manufacturing residues. You may wish to add more ventilation by opening a window.
5.To reduce the creation of soot, follow the instructions in Cleaning and Maintenance, page 10.
6.Theinstallationandprovisionsforcombustionand ventilation air must conform with the National Fuel Gas Code, ANSI Z233.1/NFPA 54, Section 5.3, Air for Combustion and Ventilation.
7.Do not run log set
•where flammable liquids or vapors are used or stored
•under dusty conditions
8.Do not burn solid fuel in the fireplace after installing the log set. Do not use this log set to cook food or burn paper or other objects.
9.Do not use appliance if any part has been exposed to or under water. Immediately call a qualified service technician to inspect the room appliance and to replace any part of the control system (if using GA9200) and any gas control which has been under water.
10.To help prevent breakage, new logs must be
11.Turn log set off and let cool before servicing, installing, or repairing. Only a qualified service person should install, service, or repair log set.
12.Provide adequate clearances around air openings.
PRODUCT
IDENTIFICATION
Grate
Burner Pan | Burner Inlet |
| (Under Pan) |
Figure 1 - Product Identification
(Ramp Pan Burner)
Hearth Kit Model ____________________
Serial Number ______________________
Log Set Model ______________________
LOCAL CODES
Install and use log set with care. Follow all local codes. In the absence of local codes, use the lat- est edition of The National Fuel Gas Code ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc. 1430 Broadway New York, NY 10018
National Fire Protection Association, Inc. Batterymarch Park Quincy, MA 02269
UNPACKING
CAUTION: Do not remove the data plates from the burner pan. The data plates contain important safety and warranty information.
1.Remove logs, hearth kit, pan materials, and hardware from carton.
2.Remove all protective packaging applied to logs and base for shipment.
3.Check all items for any shipping damage. If damaged, promptly inform dealer where you
bought the product.
4 | www.desatech.com |