Installation Instructions
10. Electrical Wiring
Consult a qualified electrician for the electrical work.
Do not connect electrical power to the unit until all electrical wiring has been completed.
Disconnect Power
This appliance must be electrically earthed in accordance with Electrical Authority Regulations.
Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
Field wiring to be performed at time of appliance installation.
WARNING
Electrical Shock Hazard
Do not turn power on until electrical wiring is finished. Disconnect power before servicing. Failure to do so may result in death or serious injury from electrical shock.
•The appliance is equipped with a 1.5m cable with a three pinned earthed plug to be connected to 240/230VAC at 50 Hz.
The power consumption may be up to 185W. Use an appropriate circuit.
•The appliance requires a 240V in Australia and 230V in New Zealand, 50Hz weatherproof plug installed in a protected position adjacent to the appliance.
•If the power cord is damaged and requires replacement, use only an original spare part available from the manufacturer.
•Do not disconnect the power supply when not in use. When the power is off, the freeze prevention in the water heater will not activate, resulting in possible freezing damage.
•Do not let the power cord contact the gas piping.
Tie the redundant power cord outside the water heater. Putting the redundant length of cord inside the water heater may cause electrical interference and faulty operation.
Earth
• To prevent electrical shock, always plug power lead into an earthed point.
CAUTION
Electrostatic discharge can affect electronic components. Take precautions to prevent electrostatic discharges from personnel or hand tools during the water heater installation and servicing to protect product’s electronic control.
13