Operation instructions
3.3Use of remote control accessory
Fig. 30 Remote control
The wireless remote control accessory and the temperature selector buttons on the front of the water heater operate identically. Contact your distributor or CEC to order if the remote control accessory is preferred. Modification of the water heaters interior control unit (Fig. 29, component 12) is required when programming the remote control with this heater.
NOTE: up to 6 remote controls can be
iprogrammed for one single water heater, each with a range distance of 98 ft (30 m).
3.4Operation
BWhen a hot water tap is opened, main burner ignites and LCD displays indication 
.
Fig. 31
BLCD blinks until selected temperature is reached.
3.5Reset button
If the LCD shows the error symbol 
.
See the error code on LCD and consult “Troubleshooting” section.
Fig. 32
After following instructions indicated in “Troubleshooting” section
Bpress reset button in order to make the appliance
Fig. 33 Reset button
If the problem persists, contact your installer.
3.6Program button
Program button can be used/programmed in the appliance and in the remote control.
Programming “Program” function
Programming actions are similar for both controls (appliance control pad and wireless remote control).
Fig. 34 “Program” key
BPress buttons 
and 
to select temperature to be memorized.
B Hold “Program” button for 3 seconds to save temperature.
When LCD stops blinking. Temperature is saved on “Program”.
Using “Program” function
In order to select memorized temperature
BPress “Program” key.
LCD shows
3.7Locked condition
This condition is only valid for appliances with more then 1 controller (appliances with remote control).
Fig. 35 Locked condition
Whenever LCD shows 
the temperature setting cannot be adjusted because the appliance is in use by a user which already selected a different temperature. Appliance will be automatically unlocked after closing hot water tap.
6 720 607 057 | 23 |