Bradford-White Corp IGE-199R, IGE-199C Control Wiring Connections Inside Water Heater

Page 28

Main Control for Commercial Models (Fig. 7)

Remote Main Control Installation:

Follow the same control installation procedure as outlined under “Temperature Control Installation” for residential models. The only exception is that only one remote temperature control can be installed.

WARNING

Do not attempt to connect the remote controls with the power on to the water heater. There are 120 volt terminals and wiring next to the remote control connections inside the unit. All servicing and wiring must be performed by a qualified installer.

Fig. 8 Control Wiring Connections Inside Water Heater

INITIAL OPERATION AND TESTING OF CONTROLS (INSTALLER ONLY)

1.Turn on power to the water heater and fully open a hot water tap.

2.Check the operation of the water heater. Check the operation of the remote temperature control(s). Check the operation of the power failure protection system (drain solenoids).

3.Explain the proper operation of the new Bradford White EVERHOT→ water heater to the customer.

28

Image 28

Contents IGE-199R and IGE-199C Model Series Section I Important Information Read CarefullyPage Do not Operate the Appliance Until the Leakage is Corrected Table of Contents Section II Specifications IGE-199R-10XEVERHOT→ IGE Model Series Dimensions Features Section III General InformationSection IV Installation Instructions Do not Operate the Appliance Until the Leakage is CorrectedUnpacking Water Heater LocationBuild Opening Clearances Fig Reference Description Minimum Distance Inches cmRemove Carton Mount Water Heater on the WallLime Condition Warning Signal Section V Water ConnectionsWater Quality Instructions for ConnectionsPage Recommended Piping for a Basic Installation Recommended Piping for Power Failure Freeze Protection Drain Solenoid Piping FigRecommended Piping for a Circulation System Page Pressure Relief Valve Never USE a Match or Open Flame for Testing Section VI GAS ConnectionsGAS Meter Size -NATURALGAS only Initial Operation and Testing Installer onlyGAS Pressure Regulation Page Section VII Electrical Connections Wiring Diagram Wiring Diagram Schematic Remote Temperature Controls Residential ModelsPage Commercial Models Control Wiring Connections Inside Water Heater Initial Operation and Testing of Controls Installer onlyTo Fill the Water Heater Section Viii Operating InstructionsSequence of Operation To Turn OFF GAS to the Appliance Lighting Instructions For Your Safety Read Before OperatingManual Gas Valve Fig Turning OFF the Water Heater for AN Extended Period of Time Residential Models see FigureMain or Bath Control For Residential Models Fig Commercial Models see FigureMain Control for Commercial Models Fig Approximate TIME/TEMPERATURE Relationships in Scalds First AID for ScaldsError Messages on Remote Temperature Control Display Section IX Maintenance Burner Flame Appearance Fig Page Lime Scale Flushing Diagram Fig Schematic Diagram of Internal Parts Section X Parts List Exploded View Internal Components Exploded View Internal Components Exploded View Electrical Parts List Anti-Frost Heater Clip