2.3Removing and replacing the control panel front cover
Removing the cover (see figure 7)
1.Remove the screw at the top centre of the control panel.
2.Push the cover upwards until the hooks at the lower end clear the burner access opening and base tray.
3.Pull the lower end of the cover slightly forward.
4.Pull the cover down until the top edge is clear of the control panel and then remove.
Replacing the cover (see figure 7)
1.Place the top of the cover inside the rim of the control panel and push it up as far as possible.
2.Position the bottom hooks inside the burner access opening and over the rim of the base tray.
3.Push the cover downwards until the lower hooks engage and the top screw holes align.
4.Replace the screw in the top centre of the cover.
2.4Setting the gas pressure
The gas pressure has been set to the correct values at the factory.
Important: The following proce- dure must be followed when checking or setting the gas pressure:
1.Shut down the heater by switching off the mains current (switch off main switch);
2.Connect a manometer to the pressure test nipple to measure the burner pressure on the gas control.
3.Activate the heater and allow the burner to ignite;
4.Check the burner pressure. If necessary, reset it by means of the burner pressure adjusting screw. Turning it
5.Shut down the heater, remove the manometer and close the pressure nipple;
6.Restart the heater (test for soundness).
AOS 1130
Figur 7 taking off and mounting the control panel
17