2.5Mounting the inner door
Mode of operation: (see figur 8).
1.Place the clips in the position on the inner door so the door can fullty stick into the opening.
2.Lift the door up and rotate it over the burner into position.
3.Pull the inner door against the inside of the skirt ring.
4.Rotate the clips into postion with a tool.
Figur 8 Removing and replacing the inner door.
1)Burner bracket
2)Inner door
3)Clip
4)Mainburner
2.6Temperature regulation
The appliance is under water supply pressure (maximum 8 bar). The amount of cold water that is added is equal to the amount of hot water used. The gas control block automatically regulates the gas supply. The main burner will ignite as soon as a reduction in water temperature is sended by the thermostat. The main burner will shut down as soon as the preset temperature is achieved.
At high water temperatures there is more scale buildup in the appliance. It is for this reason that it is recommended to place the temperature control knob in position of
60 °C as the accumulation of scale will be reduced.
5)Skirt ring
6)Outer casting
7)Base tray
18