A.O. Smith BTI 85 G, BTI 100 G manual

Page 2

Read these installation instructions first before installing the appliance. Carefully read the user instructions before igniting the appliance. Failure to follow these instructions may lead to risk of explosion and/or fire and could cause material damage and/or bodily harm. Installation and commisioning should be carried out by a qualified competent installer. The type of gas and the value at which the appliance is set standard in the factory are registered on the rating plate. The appliance may only be installed in a room if this room meets the ventilation requirements.

A.O. SMITH ACCEPTS NO RESPONSIBILITY FOR WARRANTY, SERVICE AND/OR PRODUCT LIABILITY IN CASE OF UNAUTHORISED ALTERATIONS, PRODUCT MODIFICATIONSORREPAIR.

2

Image 2
Contents BTI 85 G BTI 100 GPage Contents General General Description of the appliancePage Control panel Technical safety equipmentGas control valve Normal operation Combustion products discharge safety deviceOperation of the storage water heater Ignition failureTechnical information DimensionsDimensions BTIAOS Data Naturel GAS G20 20 mbar Technical dataUnit BTI Data Butane G30 30 mbarElectrical connection Ionisation currentFor domestic applications Installation instructionsInstallation For non-domestic applicationsWater circulation system Vented systems See figurUnvented system See figur Draught diverter Gas connectionFlue system Electrical connectionPutting into operation CommissioningFilling the water heater Shut downRemoving the cover see figure Setting the gas pressureRemoving and replacing the control panel front cover Replacing the cover see figureTemperature regulation Mounting the inner doorMagenesium anode MaintenanceConverting to another type of gas Unit BTICondensation Inlet combinationGas smell Commisioning 3 UseFault overview Failure Possible Cause Corrective ActionConditions for installation and use Guarantee in generalGuarantee of the tank Range of guaranteeClaims Appendix 1 Connection diagram BTI models Page Page 0308 253 R0