_ _OY _ COH]'ROL
ATo program one Button of a Remote Control (Figure 37):
•Locate Learn Button and Learn Indicator Light near Terminal Block on Power Head (Figure 38).
•Press and release Learn Button. Red Learn Indicator Light will blink 2 times per second.
•Press Remote Control Button once within 30 seconds. Red Learn Indicator Light will stay lit.
•Press Remote Control Button again. Red Learn Indicator Light will go out, indicating that memory is stored.
B Program each additional Remote using step A above.
7b E_'ase Ail .........._,,
_essetes frown Re e_" Mea_t BJ]e_'_'_ery
APress and hold Learn Button on Power Head for 10 seconds or until Learn Indicator Light goes out. Memory is erased:
. Program Remotes again as needed.
APush in on Battery Cover Latch at base of Remote Control (Figure 39):
Use coin, pen, screwdriver or any similar device.
-Cover snaps open.
Replace old Battery with new _EI/_'RE/ID_, A23, 12 Volt Battery.
B Snap Battery Cover closed.
WARNING
A moving garage door may cause serious injury or death.
•Keep people clear of opening while door is moving.
•Do not allow children to play with the Remote Controls. If the Safety Reverse does not work properly:
•Close the door and disconnect the Opener using the Emergency Release Cord.
•Do not use the door Opener, Remote Controls, or Wireless Keypad.
•Refer to the door and door Opener Owner'sManuals before attempting any repairs.
APress Button on Remote Control. Garage door will move.
BPress Button again. Garage door will stop:
•The door automatically stops at the end of the open or close cycle.
CPress Button again. Garage door will reverse.
NOTE
eEach Remote Control must be programmed separately.
•The Remote Controls will not cause the door Opener to close the garage door if the
•When programming the Remote Controls, they must be at least 24" from the Antenna Wire.
•Ifthe red Learn Indicator Light blinks approximately 4 times per second, programming has stopped. If programming has stopped, repeat the above steps.
Each Button on a 2 or 3 Button Remote Control is for a different Opener. You cannot use more than one Button per Remote, per Opener.
•A maximum of seven Remote Controls or
Wireless Keypads can be stored into the Receiver at one time. If a Remote Control
becomes lost, or if you want to delete a Remote Control or Wireless Keypad, see "To EraseAll Receiver Memory."
@@@
1 Button | 2 Button | 3 Button |
Remote | Remote | Remote |
® | ® | ® |
Figure 37 Genie Remote Controls
Learn Code Button
J
LEARN INDICATOR LIGHT
Figure 38 Learn Code Button and Indicator Light
Visor Clip
Push to open
Battery Cover
Model
Number
\\