APlace Magnetic Carriage Assembly Lever in "release" position.
BSlide Magnetic Carriage Assembly into slot on End Rail Section with arrow pointing away from the Power Head (Figure 12).
Magnetic | Carriage | Release |
Assembly _ | Position | |
| kCC/ |
|
Engaged | Position | (i_ .... |
To.o=
.................................. _andheader
Toward Power Head End Rail Section
Figure 12 Slide Magnetic Carriage onto Rail
A]_]'ACH RAIL STRAR TO DU© | Rail Strap | _@ |
RAIL :_E_._[l,N
AAttach Rail Strap to End Rail Section with 2
B Tighten snugly but Do Not
ALIGH'I? I I_AIL SECTIONS ;&_N©I "
AAlign all Rail Sections so Magnetic Carriage Assembly can slide freely along length of Rail.
B Securely tighten all fasteners now, Do Not
=S,>%,=I¢2 _'_ LL &S[}I " CONNECT LIIIIT
Figure 13 Attach Rail Strap
White
Wire
#8-32 x
Hex Head Screws Wire Clips
ATurn Opener right side up and support Power Head to avoid damaging the Light Bulb Sockets.
BUncoil Limit Switch Wires and retain Twist Ties.
CPlace Switches on Rail with arrows pointing away from Power Head (Figure 14).
DPlace Close Limit Switch (Brown Wire) 15" from Rail Strap. Insert (#8-32 x 1") Hex Head Screw into Switch hole and
finger-tighten until later.
Place Open Limit Switch (White Wire) 15" from Power Head. Insert (#8-32 x 1") Hex Head Screw into Switch hole and
Close Limit | Emergency | Emergency |
Switch Assembly | Release Knob | Release Tag |
Hardware (green bag)
Open Limit
Switch
@
Close Limit
Switch (Brown wire)
%.
i
15"
Wire
_15" j_- Clip
,rro..t
toward I_o_#i_
Hex Head_ |
|
Screws |
|