Chamberlain 1145, 1160, 80ad, 1150 Install the door control, Remote Control Wall Mount optional

INSTALLATION STEP 6

Install the door control

Locate the door control within sight of the door at a minimum height of 1.5m where small children cannot reach, and away from all moving parts of the door and door hardware.

1.Strip 6mm of insulation from one end of the bell wire. Connect it to the two screw terminals on the back of the door control by color: white wire to 2 and white/red wire to 1.

2.Fasten the Lighted Door Control Button securely with 6ABx1-1/2” screws. If installing into drywall, drill 4mm holes and use the anchors provided.

3.Run the bell wire up the wall and across the ceiling to the opener. Use insulated staples to secure the wire in several places. Do not pierce wire with a staple, creating a short or open circuit.

4.Receiver terminals are located on the back panel of the opener.

5.Strip 11mm of insulation from the end of the bell wire and insert in wire trap: white to 2 and white/red to 1.

6.Permanently attach the entrapment warning label to the wall near the door control, and the manual release/safety reverse test in a prominent location on the inside of the garage door.

Lighted Door	Bell Wire
Control Button
Terminal Screws
Bell Wire

WHT -2

RED -1

Lighted Door

Control Button

HARDWARE SHOWN ACTUAL SIZE

Screw 6ABx1-1/2”	Drywall Anchors	Insulated
Lighted Door Control Button		Staples

Remote Control Wall Mount (optional)

1.Locate wall mount bracket at least 1.5m above the floor.

2.Attach to the wall with 2 x ø 3.5 max flat head screws (not provided).

3.Slide remote control onto wall mount bracket.

NOTE: Tightening the wall mount screws will reduce clearance between bracket and wall.

114A2845 17