Power and Pressure Sensor Connections | Franklin 5870206300 guide

From Power Source
L1	L2
	(Input)

PRESSURE	SHUT-OFF	NO	NO
SENSOR	SHUT-OFF
		RELAY
			COM
	PFC	INV
	FAN	FAN

SW1
SW2
Sensor Connection
PRESSURE	PRESSURE
SENSOR	SHUT-OFF

Red Blk Wh Grn

Figure 3: Power and Pressure

Sensor Connections

6.Feed the 230 VAC power leads through the bottom left side of the SubDrive300 controller and connect them to the terminals marked L1, L2, and GND (Figure 3).

A 10-foot section of pressure sensor cable is provided with the controller, but it is possible to use similar 22 AWG wire for distances up to 100 feet from the pressure sensor. A 100-foot section of pressure sensor cable is available as an accessory.

7.Feedthepressuresensorleadsthroughthesmalleropeninglocatedinthe bottom middle of the SubDrive300 unit and press on the quick connect terminals.

8.Verify that the SubDrive300 unit is properly conﬁgured for the horsepower rating of the motor and pump being used. Please refer to the section on Pump Sizing for information on drive conﬁguration.

9.Replace the lid. Do not over-tighten the screws.

(Input)

Figure 3: Power and Pressure

Sensor Connections