Performance Data Sheet.
SmartWater Filtration System GXSV65F Using Filter FQSVF
■This System has been tested according to NSF/ANSI 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42 and 53.
■Actual performance may vary with local water conditions.
■Do not use with water that is microbiologically unsafe or with water of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
Hoja de datos de funcionamiento.
Cartucho FQSVF de sistema de filtración
GE SmartWater GXSV65F
■Este sistema se ha sometido a las pruebas NSF/ANSI 42 y 53 a fin de reducir las sustancias presentadas a continuación. Se redujo la concentración de las sustancias indicadas en el agua que ingresan en el sistema a una concentración menor o igual al limite permitido para el agua que sale del sistema, como se especifica en NSF/ANSI 42 y 53.
■El desempeño real puede variar de acuerdo a las condiciones locales del agua.
■No use con agua que sea microbiológicamente insegura o de calidad desconocida sin una desinfección adecuada del sistema antes o después. Los sistemas certificados para la reducción de esporas pueden ser usados en agua desinfectada que podría contener esporas filtrables.
Standard No. 42: Aesthetic Effects / Estándar No. 42: Efectos estéticos
| USEPA |
| Influent | Influent | Effluent |
| % Reduction |
| Min. Required | |
|
|
|
|
|
| |||||
Parameter | MCL |
| Challenge Concentration | Average | Average | Maximum | Average | Minimum | Reduction | |
| USEPA |
| Calidad del | Promedio | Effluyente | % de reducción | Reducción | |||
|
|
|
|
|
| |||||
Parámetro | MCL |
| influyente concentración | influyente | Promedio | Máximo | Promedio | Mínimo | mínima necesaria | |
Chlorine/Cloro | — |
| 2.0 mg/L ± 10% | 1.94 mg/L | <0.05 mg/L | <0.05 mg/L | 97.41% | 97.22% | >50% | |
T & O | — |
| — | — | — | — | — | — | — | |
Particulate**/ | — |
| ≥ 10000 particles/ | 4100000 #/mL | 24400 #/mL | 67000 #/mL | 99.35% | 97.84% | >85% | |
Partículas |
|
|
| partículas/mL |
|
|
|
|
|
|
|
|
|
| Standard No. 53: Health Effects / Estándar No. 53: Efectos relativos a la salud |
|
| ||||
Turbidity/Turbidez | 1 NTU*** |
| 11 ± 1 NTU*** | 11.08 NTU | 0.21 NTU | 0.38 NTU | 98.04% | 96.20% | 0.5 NTU | |
Cysts/Quistes | 99.95% red. |
| Min. 50000L | 141750 #/L | <1 #/L | 2 #/L | >99.99% | >99.99% | >99.95% | |
Asbestos/Amianto | 99% red. |
| 107 and/y 108 fibers/fibras/L; | 168 MF/L | 0.99885891 MF/L | <1 MF/L | 99.89% | 99.82% | >99% | |
|
|
|
| fibers/fibras >10 µm |
|
|
|
|
|
|
|
|
|
| long/de largo |
|
|
|
|
|
|
Lead/Plomo, | 0.015 mg/L |
| 0.15 mg/L ± 10% | 0.147 mg/L | <0.001 mg/L | <0.001 mg/L | 99.32% | 99.29% | 0.010 mg/L | |
pH 6.5 |
|
|
|
|
|
|
|
|
|
|
Lead/Plomo, | 0.015 mg/L |
| 0.15 mg/L ± 10% | 0.143 mg/L | <0.001 mg/L | <0.001 mg/L | 99.30% | 99.29% | 0.010 mg/L | |
pH 8.5 |
|
|
|
|
|
|
|
|
|
|
Mercury/Mercurio, | 0.002 mg/L |
| 0.006 mg/L ± 10% | 0.006033333 mg/L | <0.0002 mg/L | <0.0002 mg/L | 96.68% | 96.49% | 0.002 mg/L | |
pH 6.5 |
|
|
|
|
|
|
|
|
|
|
Mercury/Mercurio, | 0.002 mg/L |
| 0.006 mg/L ± 10% | 0.0058 mg/L | 0.000333 mg/L | 0.0005 mg/L | 94.34% | 92.06% | 0.002 mg/L | |
pH 8.5 |
|
|
|
|
|
|
|
|
|
|
Lindane | 0.0002 mg/L |
| 0.002 mg/L ± 10% | 0.002016667 mg/L | <0.00002 mg/L | <0.00002 mg/L | 99.00% | 98.95% | 0.0002 mg/L | |
Benzene | 0.001 mg/L |
| 0.015 mg/L ± 10% | 0.01417 mg/L | 0.000500 mg/L | 0.000500 mg/L | 96.47% | 96.43% | 0.005 mg/L | |
Atrazine | 0.003 mg/L |
| 0.009 mg/L ± 10% | 0.00830 mg/L | 0.002000 mg/L | 0.002000 mg/L | 74.82% | 61.54% | 0.003 mg/L | |
VOC Reduction / Reducción de VOC |
|
|
|
|
|
|
| |||
Chloroform | 0.080 mg/L |
|
| 0.30 ± 10% | 0.31429 mg/L | 0.00186429 mg/L | 0.0055 mg/L | 99.40% | 98.28% | 95% |
*Tested using a flow rate of 0.60 gpm (2.27 l/min); pressure of 60 psig; pH of 7.5 ± 0.5; temp. of 68° ± 5°F (20° ± 3°C) / Probado utilizando una tasa de flujo de 0,60 gpm (2,27 l/min); presión de 60 psig; pH de 7,5 ± 0,5; temp. de 68° ± 5° F (20° ± 3° C)
**Measurement in particles/mL. Particles used were
Operating Specifications / Especificaciones de operación
Capacity: certified for up to 160 gallons (605 l); up to six months / Capacidad: certificado para hasta 160 galones (605 l); hasta seis meses
Pressure requirement:
Temperature:
Flow rate: 0.60 gpm (2.27 l/min) / Tasa de flujo: 0,60 gpm (2,27 l/min)
Replacement Filter Canisters/Estimated Replacement Costs
For replacement parts, call
Repuesto de los cartuchos de los filtros/Costos estimados de reposición
Para repuestos, llame gratis al 800.626.2002 (EE.UU.).
6