Brother PROGRAMMABLE ELECTRONIC PATTERN SEWER, BAS-341F, BAS-342F, 342Fi instruction manual 1942S

Page 35

7. SEWING

5. Step on the presser lifter switch (2) to raise the presser foot.

6. Insert the work piece under the work clamp, and press the presser lifter switch (2) to lower the clamp.

7. Press the starting pedal (1).

Note

The work clamp will return to the origin, and will then advance to the sewing start position and blinking will stop. This is only required the first time a program is sewing.

8. Press the starting pedal (1) again to start sewing. After sewing is completed, the thread cutter will automatically operate, then the work clamp will rise.

1942S

Note

When the power is turned on after once being turned off, the same pattern of sewing can be continued since the machine will stores the sewing data from the last time.

BAS-341F, 342F

28

Image 35

Contents BAS-341F BAS-342F Safety indications and their meanings Safety InstructionsEnvironmental requirements InstallationSewing CleaningMaintenance and inspection 1971S Contents Changing Special Functions BAS-342F Name of Each PartsBAS-341F Needle SpecificationsPreparation Before setting upTilting the sewing machine head PositioningBelt tension Connecting the ground wireInstalling the foot switch Installing the programmer option Installing the spool standAdjusting the air pressure Lubrication points LubricationTo turn the pulley by hand Installing the needle and running the sewing machineCorrect USE Selecting the needle and threadThreading the upper thread Winding the lower thread Sewing conditions and thread tension Replacing the bobbin case and threading the threadLower thread tension Upper thread tension Pretension tension Explanation of panel Using the Operation PanelIndicator Switch Compatible types of floppy disk Using the floppy diskHow to use the cleaning disk Setting the floppy diskTo Read a pattern to memory Using the program R/W Read/Write switchIf an error message is displayed Clearing the errorResuming operation from a stopping poing Using the Test switch Checking the sewing patternContinuing sewing from a stopping point Using the emergency stop switchChanging the X-SCALE and Y-SCALE settings Adjusting the sewing Speed controlUsing the bobbin thread counter Using production counter Using single split mode Shifting a stitch pattern Sewing operation SewingBefore starting sewing 1942S Lubrication Maintenance and InspectionCleaning the shuttle hook Draining the oil Cleaning the control box air inlet portChecking the needle Cleaning the eye guardAdjusting the needle bar lift amount Adjusting the needle bar heightAdjusting the shuttle race thread guide Adjusting the needle clearanceAdjusting the driver needle guard Replacing the movable and fixed knives Adjusting the movable knifeMovable knife Presser foot adjustment Standard presser foot lift is 3 mm max mm Adjusting presser foot lift to 3 5mmAdjusting presser foot lift to 5 8 mm Changing the presser foot liftAdjusting the needle up stop position Adjusting the wiperChecking the input sensor and DIP switch input Checking the input voltage Clearing all memory settingsPanel DIP switch functions DIP SwitchFeeding speed is switched to high speed DIP switches inside the control box DIP Switch Changing Special Functions and Using the Memory Switches Memory switches 00 0F Switch No When on Memo-10 Extended option output Memory switches 20 2FSwitch No Possible Units Error Codes Error codes E.9 * E.F Gauge Parts List According to Subclasses Plate blank Troubleshooting Incorrect needle and shuttle hook timing Turn the sub-tension nut To adjust the tension Adjust the sub tension Sharpen or Replace Fixed knife Needle thread presser device OptionAir wiper device 15-1, Naeshiro-cho, Mizuho-ku, Nagoya 467-8561, Japan. Phone