9. STANDARD ADJUSTMENTS
1958S
2.Remove the movable knife, and replace it with a new movable knife. Now check the cutting edge of the movable knife (9) and the fixed knife (10). If necessary, use the provided movable knife washer (11) (T=0.4, T=0.5, T=0.6) to adjust the knives so that they cut properly. (Figure is
<Adjusting the engagement of the movable knife and fixed knife>
1247S |
|
| Fig. 1 |
|
| 0149S | ||
|
|
|
|
|
| Movable knife | ||
|
|
|
|
|
|
| ||
| A | B | C | D |
|
|
| |
| Cutting | (9) |
|
|
|
|
| |
| edge |
|
|
|
| Fixed | knife | |
|
| Cutting edge |
|
|
| |||
|
|
|
|
| Cutting edge | |||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| Cutting edge | |
|
|
|
|
|
|
|
|
|
0148Q |
|
|
|
|
| 0150Q | ||
|
|
|
|
|
|
|
|
|
A. After the movable knife and fixed knife are properly engaged, tighten the screw as shown in Fig.1. B. Turn the movable knife (in the direction of the arrow) while the screw is still tightened.
C. Loosen the screw.
D. Turn the movable knife (in the direction of the arrow) while the screw is still loosened.
Repeat above steps A, B, C and D four or five times to maintain the cutting performance of the knife.
3. Install the fixed knife (10) 0.5 mm away from needle hole plate (12).
1959S
35