Kenmore 625.38376 Installgroundingclampbetween, Connecting Transformer, Softener in and OUT Pipes

INSTALLGROUNDINGCLAMPBETWEEN

THE SOFTENER IN AND OUT PIPES

The house cold water pipe (iron or copper) is often used to ground all electrical outlets in the home. Outlets are grounded to protect you from shock when you touch any electric appliance plugged into the out- let. If you installed the single bypass valve, the cold water pipe ground is broken. See Fig. 20 and 21.

IMPORTANT." Be sure the cold water pipe has direct metal to metal contact all the way to the ground. Plastic, rubber or other electrically insulat- ing parts such as hoses, fittings, washers or gas- kets can break the direct metal to metal contact. Also check the water meter (city water) or the well pump. Install #4 copper jumper wires, clamped tightly on both ends, across insulated parts. See Fig. 21.

To restore the ground, take the ground clamp kit that is in the parts bag. Install across the inlet and outlet cop- per tubes. See Fig. 20. Be sure good contact is made between the pipe and the clamps.

ELECTRICAL POWER OUTLET FOR YOUR SOFTENER

The softener works on 24 volt, 60 Hz electric power. The included transformer changes standard 120 volt AC house power to 24 volts. You must plug the trans- former into a grounded, 120 volt outlet only. Be sure the outlet is always "live" so someone cannot turn it off by mistake. See Fig. 22.

NOTE: The included transformer is made for inside

use only. Be sure the electrical outlet you plug the

transformer into is inside, to protect from weather.

PLUG IN THE TRANSFORMER

Plug the transformer into the electrical outlet.

COLD WATER PiPE GROUNDING

TO

Valve Inlet

Ground

Clamp (2%

Screw with lock "_ washer and nut

FROM

Valve Outlet

FIG. 20

WATER METER JUMPER WiRE

Water Meter

#4 Groundwire

FiG. 21

CONNECTING TRANSFORMER

Transformer

120V-6OHz

Electrical

Outlet

_ From Face Plate-Timer

FiG. 22

Questions? Call The Kenmore Water Line 1-800-426-9345

16