SECTION 5
SERVICE TECH. INFORMATION
5A.TROUBLESHOOTING
AUTOMATIC ELECTRONIC DIAGNOSTICS
The faceplate timer (PWA) computer has a
input power and water meter. _,_
The computer monitors the elec-
tronic components and circuits
for correct operation. If a mal- !
function occurs, an error code {
appears in the faceplate display. - - - -
The chart below shows the error codes that could appear, and the possible defects for each code.
While an error code appears in the display, all face
plate buttons are inoperable except the SELECT button. SELECT remains operational so the service person can make the MANUAL INITIATED ELEC- TRONIC DIAGNOSTICS (below) to further isolate the defect, and check the water meter.
POSSIBLE DEFECT
CODE
Err1
Err3
Err4
Err5
MOST LIKELYLESS LIKELY
motor inoperative / wiring harness or connection to switch / position switch / faceplate timer (PWA)
motor / faceplate timer (PWA) | See faceplate timer (PWA) replacement |
timer (PWA) / position switch | on page 23. |
ifaceplate timer (PWA) |
|
PROCEDURE FOR REMOVING ERROR CODE FROM FACEPLATE: 1. Unplug transformer 2. Correct defect
3. Plug in transformer 4. Wait for 6 minutes. The error code will return if the defect was not corrected.
MANUAL INITIATED ELECTRONICS DIAG- NOSTICS
1.To enter diagnostics...
You will see 1 of the following displays. All of the
displays show what position the valve is in, if the
turbine is operating, and the position switch open or closed status.
van _ _a_
VALVE iN SERVICE
POSITION
posi_onswish ind_
-8 .28
VALVEIN k RECHARGE
POSITION(FILL IN THIS
EXAMPLE)
lutt_c_e count
FosittonImttch indicalor
(o_n)
(F¢araBrae_a_h_ng)
I | _ | minu_s of bd_ng _e |
|
|
| ||
|
| POSITIONTO | |
i_.. |
| water meW¢ | ANOTHER (FROM |
|
| uxtx_e counl | RLL TO BPJNINQ IN |
posi_nswitchindicator | THISEXAMPLE) | ||
(eked) |
|
|
|
2.Press the
POSITION SWITCH STATUS: With the valve in service, or any of the recharge cycles, the switch indicator will show open
WATER METER TURBINE: With soft water in use, the turbine flow rate display continually repeats a 000 to 140 count for each gallon of water passing through the turbine. The display will remain a steady...000 if soft
water is not in use (open a nearby soft water faucet to check).
If you don't get a reading in the display, with faucet open, pull the sensor from the valve outlet port. Pass a small magnet back and forth in front of the sensor. You
22