SECTION 1
WATER SOFTENER START-UP
3
1C. |
|
| PROGRAM THE TIMER |
| ||
salt level | low salt | #1 SELECT |
| |||
(Recharge | button | UP button | ||||
adjust button | indicator | |||||
\ | \ |
| / |
| ||
f |
|
| ||||
|
|
|
| |||
|
|
|
|
|
GeniusII WaterSo#ener
KenmoreWaterLine
forCustornerAssistance #.u_J
'_ | _ |
J
| / |
| / | display | #2 SELECT | DOWN button |
signal | light | tank | light | |||
adjust | button | on/off | button |
| button |
|
When the transformer is plugged in, the model code
HF32, and a test number (example: A2.0) show in the
faceplate display for 4 seconds. Then, 12:00 AM and PRESENT TIME begin to flash.
..... | I |
.... | C,ULI |
R20 -iT
NOTE:
If
DOWN [_ button until HF32 shows. Then, press the #1 SELECT button to set, and change to the flashing PRESENT TIME display.
To check the model code, unplug the transformer at the wall outlet and plug in again. If other than HF32 shows, see page 19 to reset.
SOUND "BEEPER": A "beeper" sounds while pressing buttons for timer
pressed_ telling you to use another button. For
example, while setting the hardness (step 2), the
beeper sounds repeatedly when the display reaches 1
using the DOWN button, or the highest hardness setting using the UP button.
1.SET PRESENT TIME OF DAY:
NOTE:
If the words...PRESENT TIME do not show in the display, press the #1 SELECT button (FIG. 1) until they do, or see the notes above.
• Press the _ UP/DOWN{_ buttons to set the
present time. Press UP to move the display ahead; press DOWN to move the time backward.
If the | present | time | is | between |
| %0- | ||
noon | and | midnight, | be | sure | PM | 'i | ||
shows. |
|
|
|
|
|
| _ltE | |
|
|
|
|
|
|
| ||
If the | present | time | is | between |
| |||
midnight | and | noon, | be | sure | AM |
|
| |
showsNOTE:. |
|
|
|
|
| I"....'", |
| |
Each | press | of the | UP/DOWN | J |
|
buttons changes the time by 1] { [ minute. Holding the buttons in"""
changes the time 32 minutes each second.
2.SET WATER HARDNESS NUMBER:
• Bress the #1 SELECT button once to display 25
(flashing) and HARDNESS.
The grains per gallon (gpg) ",'"
|
|
|
|
|
|
| 7 |
hardness | of | your | water | supply | is | _ | |
on your | water analysis | report. | Be |
| |||
sure | to | enter | water | test | results | on | *, |
page | 2, | for | future | reference. | " | " |
6